Related Experiment Video
Updated: Aug 30, 2026
Fabricating Reactive Surfaces with Brush-like and Crosslinked Films of Azlactone-Functionalized Block Co-Polymers
Published on: June 30, 2018
Initial deposition of calcium phosphate ceramic on polyethylene and polydimethylsiloxane by rf magnetron sputtering
B Feddes1, J G C Wolke, A M Vredenberg
1Department of Biomaterials, College of Dental Science, University Medical Center Nijmegen, P.O. Box 9101, 6500 HB Nijmegen, The Netherlands.
Abstract:
Calcium phosphate (CaP) coatings are well known for their bioactive nature. CaP coated polymeric materials can be used as implant material. For this, a strong adhesion between the coating and substrate is necessary. Because the chemical structure of the interface plays an important role in the coating adhesion, we studied the interface between CaP and the polymers polyethylene (PE) and polydimethylsiloxane (PDMS/silicone rubber). Both untreated and plasma pretreated polymers were used. On PE, a low Ca/P ratio nearby the interface and a high amount of C-O bonds were found on both untreated and plasma pretreated PE. This is the result of phosphate-like groups that are able to bind to the carbon of the PE. PDMS reacts towards the plasma pretreatment by losing CH(3) side groups. Compared to PE, a low amount of C-O bonds is found nearby the interface. Besides, a low Ca/P ratio is found nearby the interface. This is the result of phosphate groups that connect to Si atoms of the PDMS, thereby replacing the CH(3) side groups. The bombardment by negatively charged oxygen ions that are accelerated from the target during the deposition process makes the chemical interaction between the coating and the substrates possible.
