Multicenter determination of in vivo kinematics after total knee arthroplasty

A summation analysis of more than 70 individual kinematic studies involving normal knees and 33 different designs of total knee arthroplasty (TKA) was done with the objective of analyzing implant design variables that affect knee kinematics. Eight hundred eleven knees (733 subjects) were analyzed either during the stance phase of gait or a deep knee bend maneuver while under fluoroscopic surveillance. Fluoroscopic videotapes then were downloaded onto a workstation computer and anteroposterior (AP) femorotibial translational patterns were determined using an automated three-dimensional model fitting technique. The highest magnitude of translation was found in the normal and ACL-retaining TKA groups. Paradoxical anterior femoral translation during deep flexion was most commonly observed in PCL-retaining TKA. Substantial variability in kinematic patterns was observed in all groups. The least variability during gait was observed in mobile-bearing TKA designs, whereas posterior-stabilized TKA designs (fixed or mobile-bearing) showed the least variability during a deep knee bend. A medial pivot kinematic pattern was observed in only 55% of knees during deep knee flexion. Kinematic patterns of fixed versus mobile-bearing designs were similar with the exception of mobile-bearing TKA during gait in which femorotibial contact remained relatively stationary with minimal AP femorotibial translation.