Long-term disturbance of ground water chemistry following well installation

Ground water samples collected from a multilevel sampler shortly after its construction showed significantly higher alkalinity and concentrations of calcium and magnesium than those from nearby wells installed 10 years earlier. The sampler was drilled using a conventional hollow-stem power auger in a sandy, silicate aquifer lying beneath an isthmus between two lakes in northern Wisconsin. Ground water in the study area is of low ionic strength and its chemistry is dominated by silicate mineral weathering. Periodic sampling over two years following installation of the sampler showed that the higher solute concentrations had subsequently decreased. Oxygen isotope signature and other solute species, such as sulfate and chloride, were comparable to those of older wells and did not show any notable trends over time. Independent variation of other chemical species that cannot be derived from aquifer minerals, and the similarly high concentrations in older wells shortly after their installation, suggest that rapid dissolution of fresh mineral surfaces and hyperfine particles generated during drilling has induced the enhanced concentrations. This observation is consistent with the field equivalent of laboratory mineral dissolution experiments that show initially increased dissolution rates that decay over time. Well installations for geochemical sampling in dominantly silicate material may require longer times to reach an equilibrium state than has been previously thought.