Related Experiment Video
Updated: Aug 29, 2026

Surface Enhanced Raman Spectroscopy Detection of Biomolecules Using EBL Fabricated Nanostructured Substrates
Published on: March 20, 2015
Use of a sample translation technique to minimize adverse effects of laser irradiation in surface-enhanced Raman
M A De Jesús1, K S Giesfeldt, M J Sepaniak
1University of Tennessee-Knoxville, Department of Chemistry, 552 Buehler Hall, Knoxville, Tennessee 37996-1600, USA.
Abstract:
Surface-enhanced Raman spectroscopy (SERS) has proven to be a very powerful tool in the analysis of a wide range of compounds. However, continuous irradiation of the laser beam over the SERS substrate can promote the gross decomposition of the sample analytes and significantly broaden and diminish the intensities of observed spectral bands. In addition, the incident radiation can promote thermal or photolytic fragmentation of analytes, thereby altering the observable bands and possibly leading to a misinterpretation of analytical data. Finally, chemical or morphological changes in the SERS substrate are possible. This work presents the use of a sample translation technique (STT) as a means to minimize these adverse effects. By spinning the sample rapidly, the effective residence time of analytes and substrate within the irradiated zone is dramatically decreased without reduction of spectral acquisition time or the density of analyte in the zone. The technique is studied by acquiring SERS spectra of Naproxen USP, riboflavin, folic acid, Rhodamine 6G, and 4-aminothiophenol using silver islands on glass and silver-poly(dimethylsiloxane) composite substrates under various spinning and stationary conditions. In all cases, spectra show improvements upon spinning at laser powers as low as 4.2 (+/- 0.1) mW. Specific differences in the appearance of the spectra and the potential use of STT for improved SERS qualitative and quantitative determinations are presented.
Related Concept Videos
Raman Spectroscopy Instrumentation: Overview
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...
Raman Spectroscopy: Overview
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and the...

