Related Experiment Video
Updated: Aug 29, 2026

Measurement of Spatial Stability in Precision Grip
Published on: June 4, 2020
Distributing vertical forces between the digits during gripping and lifting: the effects of rotating the hand versus
Barbara M Quaney1, Kelly J Cole
1Center on Aging, Kansas University Medical Center, 3599 Rainbow Boulevard, Kansas City, KS 66160, USA. bquaney@kumc.edu
Abstract:
During pinch grip we partition the vertical tangential forces at the digits according to the friction at the grip surfaces, and the mass distribution of the object. However, we cannot predictively partition the vertical forces to adjust to new frictional conditions after viewing a 180-deg rotation of an object with different textures at each grip surface. Hence, the processes that lead to predictive force partitioning may not access object representations, thereby suggesting that these processes are digit-specific. If this is true, then we should fail to predictively partition our fingertip forces when we rotate our hand. We tested this prediction by comparing the effects of object rotation with hand rotation for repeated lifts of an object that had one slippery grip surface and one rough grip surface. Subjects did not predictively redistribute the vertical tangential forces upon grasping the rotated object. Following object rotation, the vertical tangential force trajectories during the first 100 ms after contact indicated that 12/15 subjects failed to anticipate the reversed digit-friction relationships. All subjects appropriately partitioned the vertical tangential forces between the digits by the second lift after object rotation, confirming previous reports that sensory signals update the memory associated with lifting the object. In contrast, after hand rotation, 13/15 subjects anticipated the new digit-friction relationships and upon grasping the object immediately generated a steep rise in the vertical force trajectory at the rough surface. They also delayed the initial rise in vertical tangential force at the digit encountering the low-friction surface by approximately 65 ms. Thus, anticipatory partitioning of vertical fingertip forces is not strictly digit-specific. Internally driven motor plans can access the relevant memories or internal models for predictively partitioning the vertical tangential forces. It is not clear if this process involves rotating internal representations of fingertip force directly, or if the forces are derived after internally rotating a representation of the object. In contrast to the robust effects of vision on reach kinematics, or on wrist and finger configuration, visual signals about object rotation and orientation apparently do not influence vertical tangential fingertip forces.
Related Concept Videos
Muscles of the Forearm that Move the Hand and Fingers
Anterior Compartment
The anterior compartment muscles originate from the humerus. They primarily function as flexors and are also known as flexor muscles. They typically insert on the carpals, metacarpals, and phalanges. The superficial layer includes the flexor carpi radialis,...
Net Torque Calculations
Muscles that Move the Forearm
Forearm Flexors
The biceps brachii, brachialis, and brachioradialis are forearm flexors. The biceps brachii is made up of two heads. Its long head originates at the supraglenoid tubercle of the scapula, whereas that of the short head is...
Torque
Torque can be considered as the rotational counterpart to force. Since forces change the translational...
Spinal Nerves: Plexus I
The Cervical Plexus
The cervical plexus, formed by the anterior rami of the first four...
Simplification of a Force and Couple System: II

