Functionalization of poly-(L-lactic-co-epsilon-caprolactone): effects of surface modification on endothelial cell...

A copolymer of L-lactic acid and epsilon-caprolactone (PLLACL) was synthesized with the aim of preparing a bioartificial, small-diameter and partially resorbable vascular graft. The material was submitted to surface functionalizations (i.e. chemical modification by means of hydrolytic 'etching' and plasma discharge) to promote endothelial cell (EC) adhesion and growth avoiding platelet adhesion or coagulation factor absorption. Furthermore, the behaviour of human microvascular endothelial cells (HMVEC) seeded on the untreated and treated copolymer is described, as well as the platelet adhesion and the modifications of coagulation factors determined by the copolymer itself. PLLACL in its native state provided little support for EC adhesion. Improved EC adherence was obtained when functional groups were provided on the polymer surface by surface chemical hydrolysis. HMVEC seeded and cultured on the polymer surface did not show any ultrastructural alteration, thus demonstrating the absence of the polymer cytotoxicity. Moreover, SEM analysis performed on cold plasma modified specimens showed the presence of a subconfluent monolayer of EC, with an elongated spread morphology. Both the untreated and treated copolymers induced only slight variations of platelet number, but determined the activated partial thromboplastin time (APTT) increase, due to factor XI reduction. Finally, a prototype of partially biodegradable vascular prosthesis was prepared with NaOH/HCl-treated copolymer. Pre-cultured HMVEC seeding of the prosthesis by means of a rotation device resulted in an almost completely coverage of the graft inner surface.