[The comparison of microleakage among three different dentin bonding agents in class V cavities]

The use of the etching technique and an enamel bonding agent may effectively reduce microleakage of the cavity wall. However, the reduction of marginal leakage relating to class V cavities, is still unsatisfactory according to the dental literature. Due to the structural difference between the dentin and the enamel, though many new dentin bonding agents have been developed lately, none of them work perfectly. In this experiment, the "silver staining technique" was used to investigate the degree of microleakage in class V resin restorations which were bonded with 3 different dentin bonding agents (Scotchbond, Scotchbond 2 and Denthesive). The sample consists of 21 caries free human molars which were divided into 3 groups: 1) Scotchbond v. s. Scotchbond 2, 2) Scotchbond v. s. Denthesive, 3) Scotchbond 2 v. s. Denthesive. Both buccal and lingual surfaces were prepared for class V cavities. The cavities were then filled with composite resin Silux, and immersed in 50% silver nitrate solution for 2 hours, and followed by washing with distilled water. After that these teeth were immersed in photodeveloping solution under the fluorescent light for 3 hours. On finishing, they were washed again, sectioned vertically into mesial and distal halves with a Isomet sectioner and put under a microscope and evaluated for the degree of microleakage with Dr. Going's method. On statistical analysis, the results of this study showed that the degree of microleakage was not significantly different among the 3 dentin bonding agents in class V resin restorations, either on the gingival wall or the occlusal wall.