A comparison of the separation ratio and coefficient alpha in the creation of minimum item sets

Trudy Mallinson1, Joan Stelmack, Craig Velozo

  • 1Clinical Research Scientist, Center for Rehabilitation Outcomes Research, Rehabilitation Institute of Chicago, Chicago, Illinois 60611, USA. trudy@northwestern.edu

Medical Care
|January 7, 2004
PubMed
Abstract

Related Concept Videos

Bonferroni Test01:10

Bonferroni Test

The Bonferroni test is a statistical test named after Carlo Emilio Bonferroni, an Italian mathematician best known for Bonferroni inequalities. This statistical test is a type of multiple comparison test to determine which means are different than the rest. Bonferroni test can minimize the Type 1 error by reducing the significance level alpha, which otherwise increases with sample pairs.
The means of different samples are first paired in all possible combinations.
The null hypothesis of the...
Multiple Comparison Tests01:13

Multiple Comparison Tests

Multiple comparison test, abbreviated as MCT, is a post hoc analysis generally performed after comparing multiple samples with one or more tests. An MCT will help identify a significantly different sample among multiple samples or a factor among multiple factors.
It would be easy to compare two samples using a significance alpha level of 0.05. In other words, there is only one sample pair to be compared. However, it would be difficult to identify a significantly different sample if the number...
One-Way ANOVA: Equal Sample Sizes01:15

One-Way ANOVA: Equal Sample Sizes

One-Way ANOVA can be performed on three or more samples with equal or unequal sample sizes. When one-way ANOVA is performed on two datasets with samples of equal sizes, it can be easily observed that the computed F statistic is highly sensitive to the sample mean.
Different sample means can result in different values for the variance estimate: variance between samples. This is because the variance between samples is calculated as the product of the sample size and the variance between the...
Optimizing Chromatographic Separations01:15

Optimizing Chromatographic Separations

Optimizing chromatographic separations is crucial for obtaining clean separations in a minimum amount of time. Optimization is required for several factors, including kinetic effects related to band broadening, plate height, capacity factor, and separation factor.
Band broadening refers to spreading solute bands as they travel through the column. This broadening can impact resolution. Plate height (H) represents the length required for one theoretical plate. A lower plate height corresponds to...
Ratio Level of Measurement00:54

Ratio Level of Measurement

The way a set of data is measured is called its level of measurement. Correct statistical procedures depend on a researcher being familiar with levels of measurement. For analysis, data are classified into four levels of measurement—nominal, ordinal, interval, and ratio.
A set of data measured using the ratio scale takes care of the ratio problem and provides complete information. Ratio scale data are like interval scale data, except they have a zero point and ratios can be calculated. For...
One-Way ANOVA: Unequal Sample Sizes01:15

One-Way ANOVA: Unequal Sample Sizes

One-way ANOVA can be performed on three or more samples of unequal sizes. However, calculations get complicated when sample sizes are not always the same. So, while performing ANOVA with unequal samples size, the following equation is used: