Polymerization contraction stress of resin composite restorations in a model Class I cavity configuration using...

An important factor that contributes to deterioration of resin composite restorations is contraction stress that occurs during polymerization. The purpose of this article is to familiarize the clinician with the characteristics of contraction stress by visualizing the stresses associated with this invisible and complex phenomenon.

Internal residual stresses generated during polymerization of resin composite restorations were determined using micro-photoelastic analysis. Butt-joint preparations simulating Class I restorations (2.0 mm x 5.0 mm, 2.0 mm in depth) were prepared in three types of substrates (bovine teeth, posterior composite resin, and transparent composite resin) and were used to examine contraction stress in and around the preparations. Three types of composite materials (a posterior composite, a self-cured transparent composite, and a light-cured transparent composite) were used as the restorative materials. The self-cured composite is an experimental material, and the others are commercial products. After treatment of the preparation walls with a bonding system, the preparations were bulk-filled with composite. Specimens for photoelastic analysis were prepared by cutting sections perpendicular to the long axis of the preparation. Fringe patterns for directions and magnitudes of stresses were obtained using transmitted and reflected polarized light with polarizing microscopes. Then, the photoelastic analysis was performed to examine stresses in and around the preparations.

When cavity preparations in bovine teeth were filled with light-cured composite, a gap was formed between the dentinal wall and the composite restorative material, resulting in very low stress within the restoration. When cavity preparations in the posterior composite models were filled with either self-cured or light-cured composite, the stress distribution in the two composites was similar, but the magnitude of the stress was greater in the light-cured material. When preparations in the transparent composite models were filled with posterior composite and light-cured transparent composite material, significant stress was generated in the preparation models simulating tooth structure, owing to the contraction of both restorative materials.

Polymerization contraction stress is an undesirable and inevitable characteristic of adhesive restorations encountered in clinical dentistry that may compromise restoration success. Clinicians must understand the concept of polymerization contraction stress and realize that the quality of composite resin restorations depends on successful management of these stresses.