Related Experiment Video
Updated: Aug 15, 2026

Standardized Hemorrhagic Shock Induction Guided by Cerebral Oximetry and Extended Hemodynamic Monitoring in Pigs
Published on: May 21, 2019
Studies to determine the critical control points in pork slaughter hazard analysis and critical control point systems
R A Pearce1, D J Bolton, J J Sheridan
1Food Safety Department, The National Food Centre, Ashtown, Castleknock, Dublin 15, Ireland.
Abstract:
Aerobic mesophilic counts (AMC), coliform (CC) and coliform resuscitation counts (CRCs) were obtained by swabbing 50 cm(2) areas at three sites (ham, belly and neck) on pig carcasses, after each of seven stages of the slaughter/dressing process (bleeding, scalding, dehairing, singeing, polishing, evisceration and chilling). In most cases, there were no statistical differences (P>0.05) among the counts derived by these three methods. Reductions in counts at individual sites were observed after scalding (3.5 log(10) cfu cm(-2)), and singeing (2.5 log(10) cfu cm(-2)). Increases in counts at individual sites were observed after dehairing (2.0 log(10) cfu cm(-2)) and polishing (1.5 log(10) cfu cm(-2)). The incidence of Salmonella on pig carcasses was also obtained by swabbing the outside surfaces of 100 half carcasses. Information on the incidence of Salmonella in scald tank water (108 samples) was also investigated. Carcass swabs and scald tank water were examined for the presence of Salmonella using standard enrichment methods. Salmonella were detected on 31% of carcasses immediately after bleeding, 7% of carcasses immediately after dehairing and evisceration, and 1% of carcasses immediately after scalding. Serovars included Salmonella Typhimurium, Salmonella Hadar, Salmonella Infantis and Salmonella Derby. No Salmonella were recovered from samples of scald tank water. The impact of pig slaughter/dressing processes on carcass microbiology and their potential use as critical control points (CCPs) during pork production are discussed.
More Related Videos
07:59Transition of Farm Pigs to Research Pigs using a Designated Checklist followed by Initiation of Clicker Training - a Refinement Initiative
Published on: August 21, 2021
05:47Simulation of a Scaled Assembly Process with Collaboration of a Robotic Arm and Monitoring through a Vision System for Quality Control
Published on: August 29, 2025
Related Concept Videos
Introduction to Statistical Process Control
Physical Methods for Controlling Microbial Growth: Temperature
Hazard Analysis and Critical Control Points (HACCP)
Investigation of Disease Outbreaks