Computer assisted localizer for planning of surgery and intra-operative orientation

There is discrepancy between the exact representation of anatomical structures and tumours in the CT or MRI scan and the more or less accurate intra-operative localisation methods based mostly upon landmarks of the skull and extracerebral space and visible abnormalities of the cerebral surface. To overcome these problems of exact intra-operative localisation a Computer Assisted Localizer (CAL) is presented which allows precise intra-operative orientation without these aids. It consists of a mechanically articulated arm with six degrees of freedom with a high precision digital incremental and an image processor for 3 D data of the head. MRI and/or CT investigation is done pre-operatively with four reference markers fixed on the patient's head. They are visible on the CT or MRI slices and are used as reference points during surgery for adjustment of the device. The co-ordinates of the digitalizer arm tip are projected into the corresponding axial, sagittal and coronal CT slices so that the system simultaneously presents three orthogonal multiplanar CT reconstructions with a reticule indicating the position of the tip of the arm. As the surgeon directs the arm to the region of interest the corresponding CT slices are displayed on the monitor at a rate of 20 slices/sec determined by the motion of the arm. The accuracy of measurement of the device itself lies within 1 mm. The accuracy is somewhat reduced however by the thickness of CT or MRI slices (routinely 2 mm slices were taken) and by deviations of the reference markers on the skin surface which amount up to 3 mm.(ABSTRACT TRUNCATED AT 250 WORDS)