Finite-element analysis of arterial anastomoses with vein, Dacron and PTFE grafts

A finite-element simulation of an end-to-end artery/graft anastomosis has been presented in this study to evaluate the distribution of compliance and stresses in the vicinity of the anastomosis due to any mismatch in compliance characteristics. The arterial wall was assumed to be made of linear isotropic elastic material in this simplified model and a static analysis was performed with a mean arterial pressure loading of the artery-graft model. Anastomoses to vein grafts and both Dacron and polytetrafluoroethylene (PTFE) grafts were studied. The results suggested the presence of a hypercompliant zone on the arterial side and a region of high tensile stresses in the wall on the graft side of the anastomosis. The presence of a hypercompliant zone has been reported from previous in vivo studies. The hypercompliance was larger with Dacron and PTFE grafts compared with that with the vein graft. However, larger tensile stresses were present in the wall of the vein graft compared with the synthetic grafts. The analysis further showed that increasing the diameter of the graft compared with the host artery to increase flow through the implant will result in a significant increase in the hypercompliance on the arterial side. Such simulation studies may prove valuable in studying the effects of compliance mismatch and suggest ways to improve the design of small diameter vascular grafts.