Related Experiment Video

Updated: Aug 26, 2026

In Situ Measurement of Vacuum Window Birefringence using 25Mg+ Fluorescence
07:03

In Situ Measurement of Vacuum Window Birefringence using 25Mg+ Fluorescence

Published on: June 13, 2020

Trivariate characteristics of intensity fluctuations for heavily saturated optical systems

Biman Das1, Eli Drake, John Jack

  • 1State University of New York, Potsdam, New York 13676, USA. dasb@potsdam.edu

Applied Optics
|February 13, 2004
PubMed

More Related Videos

Patterning via Optical Saturable Transitions - Fabrication and Characterization08:19

Patterning via Optical Saturable Transitions - Fabrication and Characterization

Published on: December 11, 2014

Rapid Repetition Rate Fluctuation Measurement of Soliton Crystals in a Microresonator07:42

Rapid Repetition Rate Fluctuation Measurement of Soliton Crystals in a Microresonator

Published on: December 15, 2021

Related Concept Videos

Intensity Of Electromagnetic Waves01:22

Intensity Of Electromagnetic Waves

The energy transport per unit area per unit time, or the Poynting vector, gives the energy flux of an electromagnetic wave at any specific time. For a plane electromagnetic wave with E0 and B0 as the peak electric and magnetic fields and traveling along the x-axis, the time-varying energy flux can be given by the following equation:
Flame Photometry: Overview01:02

Flame Photometry: Overview

Flame photometry, also known as flame emission spectrometry, is a technique used for the qualitative and quantitative analysis of elements present in a sample using a flame as the source of excitation energy. The concept of flame photometry was realized in the early 1860s by Kirchhoff and Bunsen, who discovered that specific elements emit characteristic radiation when excited in flames. The first instrument developed for this purpose was used to measure sodium (Na) in plant ash using a Bunsen...
¹H NMR: Interpreting Distorted and Overlapping Signals01:02

¹H NMR: Interpreting Distorted and Overlapping Signals

Spin systems where the difference in chemical shifts of the coupled nuclei is greater than ten times J are called first-order spin systems. These nuclei are weakly coupled, and their chemical shifts and coupling constant can generally be estimated from the well-separated signals in the spectrum.
As Δν decreases and the signals move closer, the doublets appear increasingly distorted. The intensities of the inner lines increase at the cost of those of the outer lines as the signals are slanted or...
IR Spectroscopy: Hooke's Law Approximation of Molecular Vibration01:16

IR Spectroscopy: Hooke's Law Approximation of Molecular Vibration

A covalently bonded heteronuclear diatomic molecule can be modeled as two vibrating masses connected by a spring. The vibrational frequency of the bond can be expressed using an equation derived from Hooke's law, which describes how the force applied to stretch or compress a spring is proportional to the displacement of the spring. In this case, the atoms behave like masses, and the bond acts like a spring.
According to Hooke's law, the vibrational frequency is directly proportional to the...
IR Spectrum Peak Intensity: Dipole Moment01:20

IR Spectrum Peak Intensity: Dipole Moment

The dipole moment of a bond is the product of the partial charge on either atom and the distance between them. Dipole moments influence the efficiency of IR absorption and the peak intensity. When a bond with a dipole moment is placed in an electric field, the direction of the field determines if the bond is compressed or stretched. Electromagnetic radiation consists of an electric field component that rapidly reverses direction. It follows that polar bonds are alternately stretched and...
Intensity and Pressure of Sound Waves01:05

Intensity and Pressure of Sound Waves

The intensity of sound waves can be related to displacement and pressure amplitudes by using their wave expressions and the definition of intensity. The critical step to achieve this is to write the power delivered by the particles on the wave as the product of force and velocity and simplify the force per unit area as the pressure. The velocity of the medium's particles can be derived from the displacement.
Unlike the time average of a sinusoidal term, which is zero since it is positive and...