Related Experiment Video
Updated: Aug 26, 2026

Non-radioactive in situ Hybridization Protocol Applicable for Norway Spruce and a Range of Plant Species
Published on: April 17, 2009
A comparison of red spruce and balsam fir shoot structures
1School of Forestry and Environmental Studies, Yale University, 370 Prospect Street, New Haven, Connecticut 06511, USA.
Abstract:
I compared the shoot structures of high-elevation red spruce (Picea rubens Sarg.) and balsam fir (Abies balsamea (L.) Mill.). Needle widths, thicknesses and perimeters were measured to estimate total leaf areas from measured projected leaf areas. Measured needle perimeter/needle width ratios differed significantly from estimated ratios that assumed needles were either rhomboidal or elliptical in cross section. The vertical and horizontal silhouette shoot area to total leaf area ratios (STAR(v) and STAR(h)) of the two species were negatively correlated with needle packing and canopy height. Red spruce had higher values of STAR(v) than balsam fir at each canopy height, but STAR(v) declined with canopy height at a similar rate in the two species. The STAR(h) values of the two species did not differ significantly at a given canopy height. Needle packing increased with canopy height at the same rate in the two species. Needle weight increased in red spruce and decreased in balsam fir with increased needle packing, but showed no significant dependence on canopy height. Red spruce had higher values of STAR(h) than balsam fir at low values of needle packing, but STAR(h) values converged at high values of needle packing. The generally comparable values of STAR, along with similar needle diameters, may imply that red spruce and balsam fir have similar collection efficiencies of wet and dry particles. Measurements of STAR may be used to estimate leaf area indices (LAI) more accurately when using indirect techniques.
Related Concept Videos
Softwoods and Hardwoods
Primary and Secondary Growth in Roots and Shoots
Meristems and Plant Growth
Structural Properties and Dimensions of Lumber
The strength characteristics of wood are...
Introduction to Seed Plants
Basic Plant Anatomy: Roots, Stems, and Leaves

