First principles prediction of the gas-phase precursors for AlN sublimation growth

Yanxin Li1, Donald W Brenner

  • 1Department of Materials Science and Engineering, North Carolina State University, Raleigh, NC 27695-7907, USA.

Related Concept Videos

Phase Transitions: Vaporization and Condensation02:39

Phase Transitions: Vaporization and Condensation

The physical form of a substance changes on changing its temperature. For example, raising the temperature of a liquid causes the liquid to vaporize (convert into vapor). The process is called vaporization—a surface phenomenon. Vaporization occurs when the thermal motion of the molecules overcome the intermolecular forces, and the molecules (at the surface) escape into the gaseous state. When a liquid vaporizes in a closed container, gas molecules cannot escape. As these gas phase molecules...
Phase Transitions: Sublimation and Deposition02:33

Phase Transitions: Sublimation and Deposition

Some solids can transition directly into the gaseous state, bypassing the liquid state, via a process known as sublimation. At room temperature and standard pressure, a piece of dry ice (solid CO2) sublimes, appearing to gradually disappear without ever forming any liquid. Snow and ice sublimate at temperatures below the melting point of water, a slow process that may be accelerated by winds and the reduced atmospheric pressures at high altitudes. When solid iodine is warmed, the solid sublimes...
Predicting Products: SN1 vs. SN202:27

Predicting Products: SN1 vs. SN2

Nucleophilic substitution reactions of alkyl halides can proceed via an SN1 or an SN2 mechanism. While in SN2 reactions, the nucleophile attacks the substrate simultaneously as the leaving group departs, in SN1 reactions, the substrate first dissociates to give the carbocation intermediate. Various factors such as the structure of the substrate, the strength of the nucleophile, and the nature of the solvent promote one mechanism over the other.
With increased substitution on the alkyl halide,...
Predicting Products: Substitution vs. Elimination02:52

Predicting Products: Substitution vs. Elimination

When a nucleophile and an alkyl halide react, nucleophilic substitution and β-elimination reactions compete to generate products.
The following factors can influence the mechanisms competing against each other:
Precipitation Processes01:12

Precipitation Processes

The experimental conditions in a gravimetric analysis should be optimized to maximize the particle size and purity of the obtained precipitate. Ideally, the concentration of the precipitating reagent should be low with effective stirring to maintain low relative supersaturation for the growth of large crystals. In homogeneous precipitation, the precipitant is slowly generated by a chemical reaction in the solution to avoid local reagent excesses. For example, urea decomposes gradually to...
Sublimation01:03

Sublimation

Sublimation is the direct transformation of a solid to a gaseous state. For instance, at standard pressure and room temperature, solid carbon dioxide sublimes to gaseous carbon dioxide. The phase diagram depicts the conditions required for sublimation. This process occurs at the solid-gas phase boundary and is not observed above the triple point of the substance. The reverse of sublimation is called deposition, where a gaseous substance condenses directly into a solid. Sublimation and...