Interpretation of environmental tracers in groundwater systems with stagnant water zones

Lumped-parameter models are commonly applied for determining the age of water from time records of transient environmental tracers. The simplest models (e.g. piston flow or exponential) are also applicable for dating based on the decay or accumulation of tracers in groundwater systems. The models are based on the assumption that the transit time distribution function (exit age distribution function) of the tracer particles in the investigated system adequately represents the distribution of flow lines and is described by a simple function. A chosen or fitted function (called the response function) describes the transit time distribution of a tracer which would be observed at the output (discharge area, spring, stream, or pumping wells) in the case of an instantaneous injection at the entrance (recharge area). Due to large space and time scales, response functions are not measurable in groundwater systems, therefore, functions known from other fields of science, mainly from chemical engineering, are usually used. The type of response function and the values of its parameters define the lumped-parameter model of a system. The main parameter is the mean transit time of tracer through the system, which under favourable conditions may represent the mean age of mobile water. The parameters of the model are found by fitting calculated concentrations to the experimental records of concentrations measured at the outlet. The mean transit time of tracer (often called the tracer age), whether equal to the mean age of water or not, serves in adequate combinations with other data for determining other useful parameters, e.g. the recharge rate or the content of water in the system. The transit time distribution and its mean value serve for confirmation or determination of the conceptual model of the system and/or estimation of its potential vulnerability to anthropogenic pollution. In the interpretation of environmental tracer data with the aid of the lumped-parameter models, the influence of diffusion exchange between mobile water and stagnant or quasi-stagnant water is seldom considered, though it leads to large differences between tracer and water ages. Therefore, the article is focused on the transit time distribution functions of the most common lumped-parameter models, particularly those applicable for the interpretation of environmental tracer data in double-porosity aquifers, or aquifers in which aquitard diffusion may play an important role. A case study is recalled for a confined aquifer in which the diffusion exchange with aquitard most probably strongly influenced the transport of environmental tracers. Another case study presented is related to the interpretation of environmental tracer data obtained from lysimeters installed in the unsaturated zone with a fraction of stagnant water.