Influence of form and quantity of selenium on the development and survival of an insect herbivore

Even plants classified as 'nonaccumulators' can sequester concentrations of sodium selenate, sodium selenite, selenocystine and selenomethionine that can strongly influence insect development and survival. These forms of selenium (Se), tested in diet-incorporation bioassays, proved toxic to larvae of a generalist insect herbivore at relatively low levels. Sodium selenite was the most toxic form tested against Spodoptera exigua (Hübner), with an LC(50) of 9.14 microg g(-1) wet wt (21.11 microg g(-1) dry wt). Selenocystine was intermediate with an LC(50) of 15.2 microg g(-1) wet wt. The least toxic forms, sodium selenate and selenomethionine, had LC(50)s below 50 microg g(-1) dry wt, the upper level for tissues of plants classified as nonaccumulators. Ingestion of some forms of Se also affected growth and development. Increasing concentrations of sodium selenate and sodium selenite decreased pupal weight and added significantly to the time needed for development to the pupal and adult stages. The time required to complete the larval stage increased by over 25% and the time from egg to adult emergence was extended by 22% to nearly 30%. Selenocystine and selenomethionine did not significantly increase developmental times, even at concentrations that killed 90% or more of the test populations. Analyses of relative growth rate, relative growth index, and an analysis of covariance technique for measuring growth indicated that the form of Se affected growth rates, growth inhibition responses of the larvae, and toxicological effects. Thus, quantity and the form of Se accumulating in plants grown on Se-contaminated sites are likely to influence the population dynamics of insect herbivores. The implications of these results for the ecology of contaminated sites are discussed.