The measurement of distortion: theoretical considerations

When very find measurements are recorded for the purpose of establishing distortion values, from the standpoint of accuracy, specific procedures must be developed. In the procedural system defined here, a potential major source of error is indicated and the means of overcoming this error established. From the standpoint of modern electronic technology, the use of an analogue-to-digital interface with a digital computer is considered extremely advantageous and allows the utilization of technical help to carry out the preliminary measurements. Under these circumstances, major error sources, such as reader error and calculation error, are eliminated. Further, multiple readings on each point can be made without significant sacrifice of time. This latter statement can help define the reading accuracy on each point and allows an immediate further set of readings on any point that has a large variation in the initially established set of readings. The applicability of this approach to any system in which an accurate set of readings is required to define distortion or some other parameter is limited only by the imagination of the investigator. Measuring points can be established at any desired location, and the number required is a function of the mathematical analysis being attempted. The use of a digital computer to compute the final values allows an immediate remeasurement of the initial values if necessary, since the computer response time is of the order of seconds for the calculations carried out. This is very important if changes in the experimental setup are likely to occur with time. In general, a computerized scheme such as is proposed here allows the investigator to concentrate on the experiment rather than the calculation of results. Also, the use of technical help to carry out delicate measuring procedures can allow the investigator more time to analyze the final results.