Related Experiment Video
Updated: Aug 17, 2026

Spatial Multiobjective Optimization of Agricultural Conservation Practices using a SWAT Model and an Evolutionary Algorithm
Published on: December 10, 2012
A multiobjective model for non-point source pollution control for an off-stream reservoir catchment
1Institute of Environmental Engineering, Chiao Tung University, 75 Po-Ai Street, Hsinchu, Chinese, Taiwan 300. jjkao@ensys.ev.nctu.edu.tw
Abstract:
Phosphorus loads from agricultural non-point source pollution (NPSP) significantly degrade reservoir water quality, making adequate control of agricultural NPSP necessary for improving the water quality. Controlling NPSP is generally accomplished using various Best Management Practices (BMPs). The present study applies the Agricultural Non-Point Source Pollution (AGNPS) model to simulate NPSP loading and BMP efficiencies and establishes an enhanced multiobjective mixed-integer programming model for NPSP control strategy analyses based on these results. Cost, phosphorus load, sediment load and equity are the four major objectives considered. A case study for the Posan reservoir is presented. Four commonly proposed and applicable BMPs are chosen. Non-inferior solutions obtained using the constraint method and trade-off relationships among different control objectives are described and discussed. Compared with a previously proposed fertilizer control model, results show that the model established herein is more cost-effective and achieves better phosphorus and sediment loading reduction and equity goals. Furthermore, the current model is expected to facilitate decision-making analysis for development of an appropriate cost-sharing program to encourage adoption of appropriate BMPs by farmers.
Related Concept Videos
Mechanistic Models: Compartment Models in Individual and Population Analysis
Conservation of Mass in Moving, Nondeforming Control Volume
In the context of a detention basin, the conservation of mass states that the total mass of water entering the basin must equal the mass leaving the basin plus any accumulation of...
Typical Model Studies
Design Example: Analyzing Capacity Contours for Flood Risk Assessment
Linear Approximations
Biological Treatment of Effluent and Waste Water

