The influence of morphological variation on Candida albicans adhesion to denture acrylic in vitro

Using denture acrylic pieces coated with either whole human stimulated saliva or oral streptococci, the binding ability of three different Candida albicans strains was investigated. The C. albicans strains include a clinical isolate with the commonly observed, smooth, round colonial morphology (strain 613p), a morphological variant spontaneously derived from the clinical isolate strain 613p (strain 613m1BK) and a clinical isolate from an oral lesion that was also a morphological variant upon primary isolation (strain 228). Levels of adhesion to the acrylic pieces were determined radiometrically using C. albicans cells metabolically labelled with [35S]-methionine. Whole stimulated saliva significantly increased the binding of all strains compared to uncoated acrylic. However, the level of binding of strain 613p to saliva-coated acrylic was significantly greater than the levels observed for the morphological variant strain 613m1BK. Coating acrylic pieces with either Streptococcus sanguis NCTC 10904, Strep. mutans GS-5 or Strep. sobrinus ATCC 27352 instead of saliva resulted in significantly greater binding by strain 613p compared to uncoated acrylic. Pre-coating the acrylic with the oral streptococci did not significantly increase the binding of morphological variant strains 613m1BK and 228 compared to uncoated acrylic. In general, preincubation of adherent streptococci with sucrose to induce the synthesis of extracellular carbohydrate polymers did not significantly increase the binding levels of the C. albicans strains above those observed using streptococci in buffer alone. Compared to its parental strain 613p, morphological variant strain 613m1BK adhered poorly to denture acrylic coated with either salivary constituents or oral streptococci, while strain 228 adhered to the same substrates at an intermediate level. Furthermore, physical disaggregation of clusters of the morphological variant strain 613m1BK did not appear to increase its binding capacity to saliva-coated denture acrylic. The effect of whole stimulated saliva on the adherence of C. albicans 613p to a variety of plastic substrates in addition to denture acrylic was examined. Overall, saliva pre-coating of the various plastics promoted C. albicans 613p adhesion. The adhesion of strain 613p to denture acrylic coated with whole stimulated saliva from each of five different donors or with parotid and submandibular/sublingual saliva from each of two donors was also examined. Regardless of donor, a coating of whole stimulated saliva significantly increased the binding of strain 613p to denture acrylic compared to uncoated acrylic. In addition, a coating of parotid saliva significantly increased the binding of strain 613p to denture acrylic compared to submandibular/sublingual saliva.