Nonlinear filters applied on computerized axial tomography: theory and phantom images

New nonlinear image processing techniques, in particular smoothing based on the understanding of the image, may create computerized tomography (CT) images of good quality using less radiation. Such techniques may be applied before the reconstruction and particularly after it. Current CT scanners use strong linear low-pass filters applied to the CT projections, reducing noise but also deteriorating the resolution of the image. The method in this study was to apply a weak low-pass filter on the projections, to perform the reconstruction, and only then to apply a nonlinear filter on the image. Various kinds of nonlinear filters were investigated based on the fact that the image is approximately piecewise constant. The filters were applied with many values of several parameters and the effects on the spatial resolution and the noise reduction were evaluated. The signal-to-noise ratio of a high-contrast phantom image processed were compared with the nonlinear filter, with the SNR of the phantom images obtained with the built-in CT linear filters in two scanning modes, the normal and the ultra high resolution modes. It was found that the nonlinear filters improve the SNR of the image, compared to the built-in filters, about three times for the normal mode and twice for the UHR scanning mode. The most successful filter on low-contrast phantom image was applied and it also seems to lead to promising results. These results seem to show that applying nonlinear filters on CT images might lead to better image quality than using the current linear filters.(ABSTRACT TRUNCATED AT 250 WORDS)