Structural basis of long-term potentiation in single dendritic spines

Masanori Matsuzaki1, Naoki Honkura, Graham C R Ellis-Davies

  • 1Department of Cell Physiology, National Institute for Physiological Sciences and The Graduate University of Advanced Studies (Sokendai), Myodaiji, Okazaki 444-8787, Japan.

Nature
|June 11, 2004
PubMed

Related Concept Videos

Long-patch Base Excision Repair01:02

Long-patch Base Excision Repair

Since the discovery of the two BER pathways, there has been a debate about how a cell chooses one pathway over the other and the factors determining this selection. Numerous in vitro experiments have pointed out multiple determinants for the sub-pathway selection. These are:
Type IV Collagen of Basal Lamina01:05

Type IV Collagen of Basal Lamina

Type IV collagen is a 400 nm long, network-forming collagen that acts as a barrier between the epithelial and endothelial cells. Type IV collagen  forms the backbone of the basement membrane by scaffolding with laminin, entactin, proteoglycans, and fibronectin. Apart from rendering structural support to the basement membrane, it also helps entail signaling potentials necessary for both pathological and physiological functions.
A type IV collagen molecule has six alpha chains which can exist in...
Compact Bone01:27

Compact Bone

Most bones contain compact and spongy osseous tissue, but their distribution and concentration vary based on the bone's overall function.
Compact bone, also called cortical bone, is the denser, stronger of the two types of bone tissue. It is found under the periosteum and in the diaphyses of long bones, where it provides support and protection. The microscopic structural unit of compact bone is called an osteon, or haversian system. Each osteon is composed of concentric rings of calcified...
Posttensioned Masonry Walls01:15

Posttensioned Masonry Walls


Post-tensioned masonry walls use high-strength steel rods or flexible tendons to enhance the strength and efficiency of masonry structures. These elements are securely anchored to the foundation and extend vertically either within the cores of the masonry units or between the masonry wythes. The construction process involves building the wall with these tensioning elements in place and allowing the mortar to fully cure.
Following the curing process, the tensioning begins. Steel rods are...
Design Example: Distributing Reinforcements in Concrete Sections01:22

Design Example: Distributing Reinforcements in Concrete Sections

The topic explores the practical aspects of adjusting steel reinforcements within a concrete beam section to meet specific design requirements. When designing a reinforced concrete beam, it is essential to distribute the steel reinforcements properly to ensure structural integrity and efficiency. The example provided details a scenario where a beam requires a total steel cross-section of 4 square inches. The engineer identifies that the available steel bars have a nominal diameter of 1.693...
Tensile Strength Considerations of Concrete01:16

Tensile Strength Considerations of Concrete

Considering the tensile strength of concrete involves recognizing that the theoretical strength of cement paste can be up to a thousand times higher than what is observed in practical applications. This significant discrepancy is largely attributed to the presence of microscopic cracks within the concrete. These cracks tend to amplify stress at their tips when a load is applied, a phenomenon explained by Griffith's theory of brittle fracture.
The dimensions and shape of a concrete specimen also...