Related Experiment Video
Updated: Aug 23, 2026

Shrinkage of Dental Composite in Simulated Cavity Measured with Digital Image Correlation
Published on: July 21, 2014
Calculation of contraction rates due to shrinkage in light-cured composites
Carlos Alvarez-Gayosso1, Federico Barceló-Santana, Jorge Guerrero-Ibarra
1Laboratorio de Investigación de Materiales Dentales, División de Estudios de Posgradoe Investigación, Facultad de Odontología, UNAM, Circuito de la Investigación Cientifica, Delegación Coyoacán, Ciudad Universitaria, Mexico. calvarezg@infosel.net.mx
Objective:
To calculate the contraction rate that results from polymerization shrinkage in photo-cured resins.
Method:
Fourteen materials were irradiated in a previously developed instrument. This instrument uses measurements of deflection using a 'bonded disk' method. Six measurements were made on each material at 20 +/- 2 degrees C and 70 +/- 10% RH. Means and standard deviations were analyzed.
Results:
Shrinkage-strain and contraction rate are reported. Total shrinkage-strain for photo-polymerized resins (packable and flowable composites) varies between 1.65 and 4.16%. Both are ormocers. The contraction rate for photo-polymerized resins varies between 55.71 and 167.00 microm/min. Packable resins present a lower contraction rate than flowable resins.
Significance:
The distance-time graph is linear. The slope of this line is the average velocity. This concept was used to calculate the average contraction rate. The monomer percentage affects the contraction rate, because higher contraction rate means higher percentage of monomer. We can infer that contraction rate bears some relation to polymerization shrinkage.
Related Concept Videos
Shrinkage in Concrete
When concrete is still in its plastic state, it can undergo a decrease in volume by about 1% of its absolute volume. This decrease is known as plastic shrinkage. It arises either...
Drying Shrinkage
A portion of this drying shrinkage can be reversed; if the concrete is...
Carbonation Shrinkage
The concrete's permeability is slightly reduced as calcium carbonate produced during the reaction fills its pores. Furthermore, its strength is slightly enhanced as the water released during the reaction facilitates the...
