Early bond strength of luting cements to a precious alloy

Previous studies have reported that glass-ionomer and adhesive resin cements can bond to various alloys, while zinc phosphate cements lack this adhesive property. This study evaluated the bonding properties of three luting cements during the first seven days after cementation. Thirty cylinders were cast with a high-noble porcelain-fused-to-metal (PFM) alloy and luted in pairs with one of the cements. The joints were stored in water at 37 degrees C for one, two, or seven days before being fractured in shear. The cylinders were re-used to provide 40 joints within each test group. The data were subjected to a Weibull analysis, a curve-fitting method shown to be appropriate for comparing the bond strengths of dental materials. The results showed that the zinc phosphate cement was the weakest material, whereas the adhesive resin produced the strongest joints. Microscopic observations of the fractured samples did not reveal any specific differences between the samples in terms of their mechanism of fracture. The glass-ionomer cement reached its maximum bond strength after two days, whereas storage time had no influence on the zinc phosphate cement. The adhesive resin cement was slightly, but not significantly, weaker after one week in water. We suggest that excessive loading of restorations cemented with glass ionomer should be avoided for the first two days after the placement. The use of an adhesive resin cement can be recommended on endodontically treated teeth, but further studies are needed to evaluate its biocompatibility and adhesion to dentin.