Microleakage of cervical cavities restored with flowable composites

To investigate the microleakage of cervical cavities restored with flowable composites in conjunction with an all-in-one adhesive system (AQ Bond) and an experimental two-step self-etching primer system (ABF) after thermocycling or flexural load cycling.

180 wedge-shaped cervical cavities on the labial surfaces of bovine incisors were treated with AQ Bond or ABF according to the manufacturers' instructions. The treated cavities were filled with one of three flowable composites (AElite Flo, Metafil Flo or Protect Liner F). Ten of 30 specimens for each group were immersed in 0.5% basic fuchsin solution immediately after finishing of the restorations. Specimens to be subjected to thermocycling (5-60 degrees C, 15 seconds dwell time, 5000 cycles) or to flexural load cycling (approximately 0.5 mm labio-lingual displacement at the incisal edge, 10,000 cycles, 1 Hz) prior to immersion in the dye were also prepared. After 24-hour storage in the dye solution, the teeth were sectioned longitudinally through the center of the restorations, and the degrees of dye penetration scored. The microleakage scores of a hybrid composite (Clearfil AP-X) obtained from our previous study were used for comparison. The data were analyzed with the Kruskal-Wallis test and the Mann-Whitney U-test (P < 0.05).

No significant differences in the microleakage patterns and scores were found among the flowable composites. On the other hand, significant differences in the microleakage patterns and scores were observed between the flowable and the hybrid composites. Thermocycling caused deterioration of marginal integrity, and the flowable composites showed more microleakage than the hybrid composite. In contrast, flexural load cycling did not cause deterioration of the marginal integrity when the cavities were filled with the flowable composites. Statistical analysis also revealed that the adhesive systems played a large role in the microleakage patterns.