Effect of pH and ionic strength on competitive protein adsorption to air/water interfaces in aqueous foams made with...

Quantitative analysis of competitive milk protein adsorption to air/water interfaces in aqueous foam was performed by capillary electrophoresis (CE). Foams were made by whipping protein solutions, in which skim milk powder (SMP) and whey protein isolate (WPI) were mixed at 0.5% protein in different proportions at different pH values and NaCl concentrations. Preferential adsorption of beta-casein into foam phases occurred under most solution conditions, if partial dissociation of the casein micelles had occurred. Preferential adsorption of beta-casein was not observed with added Ca2+, due to the re-association of casein micelles. Enrichment of caseins into the foam phase was more apparent than that of whey proteins. The foamability of SMP demonstrated a continuous improvement due to the gradually increasing dissociation of casein micelles when the concentration of NaCl increased from 0 to 0.8 M. The foamability of WPI increased when NaCl concentration rose from 0 to 0.1 M, and decreased with further increase in NaCl concentration. NaCl at low concentration (I < or = 0.4) did not show a significant effect on the competitive adsorption among milk proteins, indicating that electrostatic interactions do not play a key role in competitive adsorption. NaCl at higher concentration, e.g., 0.6 M, caused less whey protein to be adsorbed to the air/water interfaces. The whippability of WPI was highest at pH 4.5 and lowest at pH 3, and that of SMP was the opposite. The proportions of beta-lactoglobulin and alpha-lactalbumin in the foam phase were lower at acidic pH and higher at basic pH, compared with that at natural pH of WPI.