Related Experiment Video

Updated: Aug 23, 2026

Controlled Synthesis and Fluorescence Tracking of Highly Uniform Poly(N-isopropylacrylamide) Microgels
11:34

Controlled Synthesis and Fluorescence Tracking of Highly Uniform Poly(N-isopropylacrylamide) Microgels

Published on: September 8, 2016

An estimate of random close packing density in monodisperse hard spheres

Payman Jalali, Mo Li

    The Journal of Chemical Physics
    |July 23, 2004
    PubMed
    Abstract

    No abstract available in PubMed .

    More Related Videos

    Assembly and Characterization of Polyelectrolyte Complex Micelles08:44

    Assembly and Characterization of Polyelectrolyte Complex Micelles

    Published on: March 2, 2020

    Related Concept Videos

    Crystal Density01:19

    Crystal Density

    The crystal lattice structure of a material allows us to determine how many molecules exist in its unit cell. With this information, alongside the unit-cell parameters - three distance parameters (a, b, c) and three angular parameters (α, β, γ).Density (ρ) = (Z × M) / (a × b × c × NA)where:Z is the number of formula units per unit cellM is the molar mass of the substancea, b, and c are the edge lengths of the unit cellNA is Avogadro’s numberFor a simple cubic lattice, atoms are located only at...
    Density00:56

    Density

    Density is an important characteristic of substances, crucial in determining whether an object sinks or floats in a fluid. Its SI unit is kg/m3, and its cgs unit is g/cm3. The density of an object helps in identifying its composition, and also reveals information about the phase of the matter and its substructure. The densities of liquids and solids are roughly comparable, consistent with the fact that their atoms are in close contact. However, gases have much lower densities than liquids and...
    Polymers: Molecular Weight Distribution01:10

    Polymers: Molecular Weight Distribution

    For any given polymer, the weight average molecular weight (Mw) is higher than, if not equal to, the number average molecular weight (Mn). The only situation in which the weight average molecular weight and the number average molecular weight are equal is when a polymer consists only of chains with equal molecular weight. However, this never happens in a synthetic polymer, since it is difficult to control the polymerization process up to a molecular level with accuracy to a hundred percent.
    Mean free path and Mean free time01:22

    Mean free path and Mean free time

    Consider the gas molecules in a cylinder. They move in a random motion as they collide with each other and change speed and direction. The average of all the path lengths between collisions is known as the "mean free path."
    Pore Size Distribution01:23

    Pore Size Distribution

    In concrete, the pore size distribution significantly influences the material's properties. Capillary pores, markedly larger than gel pores, form a vast network within partially hydrated cement paste, reducing the concrete's strength and increasing its permeability. This heightened permeability leads to a greater risk of damage from environmental factors like freeze-thaw cycles and chemical attacks, with the extent of vulnerability also being tied to the water-to-cement ratio.
    Adequate...
    Maxwell-Boltzmann Distribution: Problem Solving01:20

    Maxwell-Boltzmann Distribution: Problem Solving

    Individual molecules in a gas move in random directions, but a gas containing numerous molecules has a predictable distribution of molecular speeds, which is known as the Maxwell-Boltzmann distribution, f(v).
    This distribution function f(v) is defined by saying that the expected number N (v1,v2) of particles with speeds between v1 and v2 is given by