Related Experiment Video
Updated: Aug 23, 2026

Gas Chromatography-Mass Spectrometry Paired with Total Vaporization Solid-Phase Microextraction as a Forensic Tool
Published on: May 25, 2021
Optimization of solid-phase microextraction for the gas chromatography/mass spectrometry analysis of persistent
Ana Gago-Martínez1, María J Nogueiras, Sandra Rellán
1Universidad de Vigo, Departamento de Química Analítica y Alimentaria, Campus Universitario Vigo, Vigo, Spain. anagago@uvigo.es
Abstract:
In this work, solid-phase microextraction (SPME) has been applied as an alternative for the selective extraction of 3 polybrominated diphenyl ethers (PBDEs), 2,2',4,4'-tetrabromodiphenyl ether (PBDE-47); 2,2',4,4',5-pentabromodiphenyl ether (PBDE-99); and 2,2',4,4',6-pentabromodiphenyl ether (PBDE-100), and 2 alkylphenols, 4-tert-OP and 4-NP, prior to their analysis by gas chromatography/mass spectrometry (GC/MS). The advantages of this technique are mainly its simplicity, cost-effectiveness, and time-saving sample preparation, as well as being a solvent-free technique. With the aim of optimizing the conditions for an efficient extraction of the studied compounds, different fiber coatings and the main parameters affecting the extraction procedure have been evaluated. The results obtained showed a good linearity in the range of concentrations investigated, and adequate relative standard deviation values were found according to the range accepted for SPME. Recovery values were in the range of 78-108%, and good detection and quantitation limits at ppt levels were obtained for both methods, allowing the determination of the selected compounds in samples at trace levels. The results obtained clearly show the potential of SPME for efficient concentration of the target compounds and also demonstrate the reliability of this extraction technique for their GC/MS analysis.
Related Concept Videos
Gas Chromatography: Introduction
In GC, a sample is vaporized and mixed with an inert carrier gas (the mobile phase), which transports it through a column.
Gas Chromatography–Mass Spectrometry (GC–MS)
A gas chromatograph consists of a long, narrow capillary column with a polysiloxane coating on the inner wall. The coating...
Gas Chromatography: Types of Columns and Stationary Phases
For an analyte to remain on the column for a sufficient amount of time, it must exhibit some level of compatibility (or...
High-Performance Liquid Chromatography: Elution Process
Optimizing Chromatographic Separations
Band broadening refers to spreading solute bands as they travel through the column. This broadening can impact resolution. Plate height (H) represents the length required for one theoretical plate. A lower plate height corresponds to...
High-Performance Liquid Chromatography: Introduction
In HPLC, two phases play a critical role in the separation process:

