Use of different D-dimer levels to exclude venous thromboembolism depending on clinical pretest probability

L A Linkins1, S M Bates, J S Ginsberg

  • 1Department of Medicine, Henderson Research Center, McMaster University, Hamilton, Canada.

Currently, the same D-dimer cut-off point is used to define a positive result for all patients with suspected venous thromboembolism, regardless of their pretest probability. However, use of a relatively high D-dimer cut-off point (lower sensitivity) for those with a low clinical pretest probability, and a low D-dimer cut-off point (higher sensitivity) for those with a high clinical pretest probability, may be preferable. To determine if using three different D-dimer cut-off points according to low, moderate or high clinical pretest probability has greater utility for exclusion of venous thromboembolism than using the same single D-dimer cut-off point in all patients. Data from a previously published study of 571 patients was used to identify the highest D-dimer cut-off point with a negative predictive value of at least 98% for the subgroup of patients with low and high pretest probability. The D-dimer cut-off point for those with moderate clinical pretest probability remained unchanged [0.5 fibrinogen equivalent units (FEU) microgram mL(-1)]. Accuracy of D-dimer testing for venous thromboembolism using three cut-off points vs. one cut-off point was than determined. D-dimer cut-off points of 0.2 and 2.1 FEU microgram mL(-1) were selected for the high and low pretest probability groups, respectively. When three pretest probability-specific cut-off points were used instead of the previously determined single D-dimer cut-off point (0.5 FEU microgram mL(-1)), sensitivity and negative predictive value were unchanged (95 and 98%, respectively), but specificity increased from 44.7 to 60.4% (P < 0.001). This resulted in exclusion of venous thromboembolism in 80 additional patients. Use of three pretest probability-specific D-dimer cut-off points rather than a single D-dimer cut-off point for all patients, has the potential to increase the utility of D-dimer testing for the diagnosis of venous thromboembolism.

Related Concept Videos

Venous Thrombosis II: Clinical Manifestations and Diagnostic Studies01:20

Venous Thrombosis II: Clinical Manifestations and Diagnostic Studies

The key difference between Superficial Vein Thrombosis (SVT) and Deep Vein Thrombosis (DVT) lies in their location and severity.Clinical ManifestationsSVT typically presents with localized pain, tenderness, and redness along the course of a superficial vein, often accompanied by a palpable, cord-like structure under the skin. This condition is usually less dangerous than DVT but can be uncomfortable and may lead to complications such as cellulitis or, rarely, a clot extension into the deep...
Venous Thrombosis III: Interprofessional Care01:29

Venous Thrombosis III: Interprofessional Care

Venous thrombosis requires effective prevention and treatment strategies to improve patient outcomes and reduce potential complications.Prevention StrategiesHealthcare providers must prioritize preventing venous thromboembolism (VTE) for all adult patients upon admission. Interventions depend on bleeding and thrombosis risk, medical history, current medications, diagnoses, planned procedures, and patient preferences. Patients on bed rest should change positions every two hours and, if not...
Pulmonary Embolism II: Diagnostic Studies and Interprofessional Care01:29

Pulmonary Embolism II: Diagnostic Studies and Interprofessional Care

Diagnosing Pulmonary EmbolismDiagnosing pulmonary embolism (PE) involves clinical assessment and advanced imaging tests. The preferred diagnostic tool is the spiral (helical) CT scan or CT angiography (CTA), which uses intravenous contrast media to visualize the pulmonary vasculature and identify emboli.A ventilation-perfusion (V/Q) scan is an alternative for patients unable to receive contrast media. This scan includes both perfusion and ventilation scanning. Perfusion scanning involves...
Effects of EDTA on End-Point Detection Methods01:18

Effects of EDTA on End-Point Detection Methods

Different methods, such as visual observance of metal-ion indicators, spectroscopic techniques, and potentiometric methods, can determine the endpoint of an EDTA titration.
In the visual method, metal-ion indicators (metallochromic dyes), which have distinct colors in their free and complex forms, are added to the mixture to signal the titration's end point. They form stable complexes with metal ions, but these complexes are weaker than the corresponding metal–EDTA complexes. As a result, EDTA...
Anticoagulant Drugs: Low-Molecular-Weight Heparins01:30

Anticoagulant Drugs: Low-Molecular-Weight Heparins

Hemostasis is a crucial process that prevents excessive blood loss from damaged blood vessels. It involves various mechanisms such as vasoconstriction, platelet adhesion and activation, and fibrin formation. The importance of each mechanism depends on the type of vessel injury. In contrast, thrombosis is the abnormal formation of a blood clot within the blood vessels, leading to potential complications if the clot obstructs blood flow. Thrombosis can be caused by increased coagulability of the...