Related Experiment Video

Updated: Aug 22, 2026

Removal of Trace Elements by Cupric Oxide Nanoparticles from Uranium In Situ Recovery Bleed Water and Its Effect on Cell Viability
09:23

Removal of Trace Elements by Cupric Oxide Nanoparticles from Uranium In Situ Recovery Bleed Water and Its Effect on Cell Viability

Published on: June 21, 2015

The adsorption behavior of natural sand in contact with uranium contaminated seawater

Gulten Atun1, Ayben Kilislioglu

  • 1Engineering Faculty, Chemistry Department, University of Istanbul, 34850, Avcilar, Istanbul, Turkey. gultena@istanbul.edu.tr

Journal of Environmental Science and Health. Part A, Toxic/Hazardous Substances & Environmental Engineering
|August 27, 2004
PubMed

More Related Videos

Removal of Arsenic Using a Cationic Polymer Gel Impregnated with Iron Hydroxide08:01

Removal of Arsenic Using a Cationic Polymer Gel Impregnated with Iron Hydroxide

Published on: June 28, 2019

Two-way Valorization of Blast Furnace Slag: Synthesis of Precipitated Calcium Carbonate and Zeolitic Heavy Metal Adsorbent11:14

Two-way Valorization of Blast Furnace Slag: Synthesis of Precipitated Calcium Carbonate and Zeolitic Heavy Metal Adsorbent

Published on: February 21, 2017

Related Concept Videos

Microbial Bioremediation of Uranium01:25

Microbial Bioremediation of Uranium

Microorganisms play a critical role in the transformation and immobilization of uranium in contaminated environments through four main pathways: bioreduction, biosorption, bioaccumulation, and biomineralization. These mechanisms reduce uranium’s toxicity and prevent its migration through groundwater systems, offering sustainable approaches for in situ bioremediation.Bioreduction of UraniumBioreduction is driven by anaerobic bacteria such as certain strains of Geobacter and Shewanella, which use...
Deleterious Substances in Aggregate01:25

Deleterious Substances in Aggregate

Deleterious substances in aggregates can be detrimental to the quality and durability of concrete. These substances include organic impurities like loam, which interfere with cement hydration and are usually present in the sand. These prevent a good bond between aggregate and cement paste. Organic impurities can be detected using the colorimetric test, where the darkness of a solution after agitation indicates the level of organic content.
Another type of impurity is clay and fine material that...
Design Example: Aggregate Gradation01:24

Design Example: Aggregate Gradation

The right type and quality of aggregates are crucial for concrete as they significantly influence its properties, mix proportions, and cost-effectiveness. If different sources are available for sand, the commonly used fine aggregate in concrete, the selection of sand is primarily based on its gradation.
The grading, or particle-size distribution, of sand is determined using sieve analysis, with standard sizes ranging from 150 μm to 10 mm (ASTM No. 100 sieve to 3⁄8 in. sieve). Sand is sampled...
Effect of Sea Water on Concrete01:22

Effect of Sea Water on Concrete

Concrete exposed to seawater can undergo degradation like the dissolution of ettringite and gypsum, increasing the material's porosity and decreasing its strength. In contrast, the crystallization of salts within the concrete's pores can cause expansion, particularly above the waterline where evaporation occurs. Nonetheless, this expansion only happens when seawater, enabled by the concrete's permeability, manages to infiltrate the structure.
Concrete in areas between tide marks, which undergo...