Long-term ethylene oxide exposure trends in US hospitals: relationship with OSHA regulatory and enforcement actions

Anthony D LaMontagne1, J Michael Oakes, Ruth N Lopez Turley

  • 1Centre for the Study of Health and Society, Department of Public Health, School of Population Health, University of Melbourne, Melbourne, Victoria, Australia. alamonta@unimelb.edu.au

Abstract

Related Concept Videos

Methods of Sterilization II: Chemical Methods01:30

Methods of Sterilization II: Chemical Methods

In healthcare, the chemical method of sterilization uses chemical sterilants to treat surgical instruments and medical supplies to help prevent the transmission of infectious pathogens to patients. Due to heat sensitivity, most medical supplies and equipment should not be exposed to high temperatures. These parts include rubber, plastic, glass, and other similar elements.
Using chemical sterilization rather than heat to clean out equipment is recommended. It eradicates and removes all bacteria,...
Toxicity Testing in Animals01:23

Toxicity Testing in Animals

Toxicity tests in animals are grounded on two main assumptions: first, the effects observed in laboratory animals can be extrapolated to humans, especially when adjusted for body surface area; second, high-dose exposure in animals is essential to identify potential human hazards from lower doses. This is based on the quantal dose-response concept, which faces the challenge of extrapolating results from relatively few test animals to much larger human populations. For example, a 0.01% incidence...
PPE Use in Healthcare Settings I: Donning01:22

PPE Use in Healthcare Settings I: Donning

Donning PPE must be completed before contact with the patient. This process protects from infectious agents. The sequence and action included in each donning are critical, and the steps must be systematic to avoid exposure to pathogens. The institutional policy also needs to be followed while donning PPE. The pre-donning preparations are gathering equipment, inspecting the PPE equipment for tears, holes, or damage, removing jewelry, removing any garments below the elbows, and tying the hair...
PPE Use in Healthcare Settings II: Doffing01:10

PPE Use in Healthcare Settings II: Doffing

The sequence of removing or doffing PPE starts with the gloves, as they are the most contaminated. Next is removal of the face shield or goggles, as they would interfere with removing other PPE. Then remove the gown, followed by the mask or respirator. Perform hand hygiene between steps if hands become contaminated and immediately after removing all PPE. Generally, the outside front and sleeves of the isolation gown, the goggles or the mask, the respirator, and the face shield are contaminated.
Healthcare Associated Infections II: Preventive Measures01:22

Healthcare Associated Infections II: Preventive Measures

Essential infection prevention measures are based on the knowledge of the infection chain, the modes of transmission in healthcare settings, and the use of the best practices in all healthcare settings. Compulsory public reporting of healthcare-associated infection rates is needed to allow individuals and the community to make informed choices regarding selecting a healthcare facility.
The best practices for preventing healthcare-associated infections include hand hygiene, patient risk...
Transmission-based Precautions II: Airborne and Protective Environment01:25

Transmission-based Precautions II: Airborne and Protective Environment

Transmission-based precautions are for patients infected or suspected to be infected (or colonized) with organisms posing a significant risk to others. The transmission precautions include airborne and protective environment precautions.
Airborne precautions:
Use airborne precautions when treating patients known or suspected to have diseases that spread through the air—for example, tuberculosis or measles. These organisms are present in smaller droplets expelled by an infected person and...