Related Experiment Video
Updated: Aug 22, 2026

Clean Sampling and Analysis of River and Estuarine Waters for Trace Metal Studies
Published on: July 1, 2016
Concentration and fate of trace metals in Mekong River delta
1Institute for Environment and Sustainability, Joint Research Centre, via Fermi, 21020 Ispra (VA), Italy.
Abstract:
In the Mekong River delta and its associated coastal zone trace elements concentrations (Cd, Cu, Ni and Pb) were measured in the dissolved phase (DP) during dry (March 1997) and wet (October 1997) seasons. As, Co, Cr, Ni, Pb, and Al were also measured in suspended matter (SM) and total and organic carbon, trace elements (Cd, Cr, Cu, Hg, Mn, Ni, Pb, Zn) and macro elements in superficial sediments (S). Trace metal concentrations in DP and SM during the contrasting hydrological conditions were generally found within the range observed for uncontaminated environment. The average DP concentrations (nM) in the river for March and October are: Cd 0.03 and 0.09, Cu 15 and 14, Ni 7.8 and 8.4, Pb 0.51 and 0.50, respectively. In general there is no significant difference between the concentrations observed during dry and wet season. The evolution of the DP trace metal concentration in the surface water within the salinity gradient suggests no noticeable exchange between the particulate and dissolved phase. This result is in good agreement with those observed in most plume structures studied so far. The average concentrations in the SM (microg/g) (March, October) at the river end-member are: As (24; 11), Co (17; 9), Cr (49; 29), Ni (32; 18), Pb (42; 19) and Al (113,000; 67,000), respectively. All trace elements show higher concentrations in March than in October, with an average increase of two times. This is essentially related to grain size effect since smaller particles were supplied during dry season. These differences are not reflected in the mixing zone, which integrates the seasonal variations. The concentration of major elements (C total, C organic, Si, Al, Ca, K, Fe, Mg, Ti), trace elements (Pb, Zn, Cu, Ni, Mn, Cr, Cd, Hg) in superficial sediments, show similar values during the two seasons and does not show any important variation with depth, indicating either a very fast sedimentation rate and/or the absence of any significant contamination.
Related Concept Videos
Microbes and Other Elemental Cycles
Extraction: Advanced Methods
Complexometric EDTA Titration Curves
Voltammetry: Stripping Methods
Anodic Stripping Voltammetry (ASV)
ASV is used to determine metals and metalloids at trace levels. It involves two steps: deposition and stripping. First, a negative potential is applied to the...
Precipitation and Co-precipitation
Microbial Leaching

