Experimental measurement and numerical analysis on resonant characteristics of piezoelectric disks with partial...

Three experimental techniques are used in this study to access the influence of the electrode arrangement on the resonant characteristics of piezoceramic disks. These methods, including the amplitude-fluctuation electronic speckle pattern interferometry (AF-ESPI), laser Doppler vibrometer-dynamic signal analyzer (LDV-DSA), and impedance analysis, are based on the measurement of full-field displacement, pointwise displacement, and electric impedance, respectively. In this study, one full electrode design and three nonsymmetrical partial electrode designs of piezoelectric disks are investigated. Because the clear fringe patterns measured by the AF-ESPI method will be shown only at resonant frequencies, both the resonant frequencies and the corresponding vibration mode shapes are successfully obtained at the same time for out-of-plane and in-plane motions. The second experimental method is the impedance analysis, which is used to measure the resonant and antiresonant frequencies. In addition to these experimental methods, LDV-DSA is used to determine the resonant frequencies of the vibration mode with out-of-plane motion. From the experimental results, the dependence of electrode design on the vibration frequencies and mode shapes is addressed. Numerical computations based on the finite element method are presented, and the results are compared with the experimental measurements. The effect of different designs of electrode is more significant in the in-plane modes than that in the out-of-plane modes.