The semi-interpenetrating polymer network matrix of fiber-reinforced composite and its effect on the surface adhesive...

This aim of this study was to examine the effect of further-impregnation time of polymer pre-impregnated fiber-reinforcement on polymer matrix structure of the fiber-reinforced composite (FRC) used in dental applications. In addition, shear bond strength between the FRC and veneering composite after various length of further-impregnation was studied. Polymethyl methacrylate (PMMA) pre-impregnated glass fiber-reinforcement was further-impregnated with a diacrylate monomer resin by using five lengths of further-impregnation from 10 min to 24 h. The test specimens (n=5) from each five groups were treated with the solvent tetrahydrofuran and examined with a scanning electron microscope (SEM) to determinate the existence of linear PMMA in the polymer matrix of the FRC. The same lengths of further-impregnation were used to form an adhesive substrate for veneering composite and to measure the shear bond strength (n=8). The SEM examination showed that linear PMMA-polymer and cross-linked diacrylate polymer formed two independent networks for the polymer matrix of FRC. The highest mean shear bond strength value (18.7+/-2.9 MPa) was achieved when the fiber reinforcement was further-impregnated for 24 h. The shortest further-impregnation, 10 min, resulted in the lowest mean shear bond strength (12.7+/-2.9 MPa). A correlation between increased shear bond strength and longer further-impregnation was found (0.689, p<0.001). The results revealed that linear PMMA network of the polymer matrix of the FRC remained in the structure regardless of the various lengths of the further-impregnation with diacrylate resin.