Related Experiment Video
Updated: Aug 15, 2026

An In Vitro Organ Culture Model of the Murine Intervertebral Disc
Published on: April 11, 2017
Spatial and structural dependence of mechanical properties of porcine intervertebral disc
F Causa1, L Manto, A Borzacchiello
1Institute of Composite Materials Technology-CNR, CRIB University of Naples Federico II, P.le Tecchio 80, 80125, Naples, Italy.
Abstract:
Structure-function relationship of natural tissues is crucial to design a device mimicking the structures present in human body. For this purpose, to provide guidelines to design an intervertebral disc (IVD) substitute, in this study the influence of the spatial location and structural components on the mechanical properties of porcine IVD was investigated. Local compressive stiffness (LCS) was measured on the overall disc, also constrained between the two adjacent vertebrae: the dependence on the lumbar position was evaluated. The compliance values in the anterior position (A) were higher than both in the central posterior (CP) and in the lateral-posterior (RP, LP) locations. The values of Young's Modulus (74.67+/-6.03 MPa) and compression break load (1.36x10(4)+/-0.09x10(4)N) of the disc were also evaluated by distributed compression test. The NP rheological behavior was typical of weak-gels, with elastic modulus G' always higher than viscous modulus G" all over the frequency range investigated (G' and G" respectively equal to 320 and 85 Pa at 1 Hz) and with the moduli trends were almost parallel to each other.
Related Concept Videos
Relation between Poisson's ratio, Modulus of Elasticity and Modulus of Rigidity
Bending of Members Made of Several Materials
Hooke's Law determines stress in each material, stating that stress is proportional to strain but varies due to each material's...
Herniated Intervertebral Disc l: Introduction
Degenerative Disc Disease I: Introduction
Degenerative Disc Disease ll: Pathophysiology

