Related Experiment Video
Updated: Aug 22, 2026

Lab-Scale Model to Evaluate Odor and Gas Concentrations Emitted by Deep Bedded Pack Manure
Published on: July 19, 2018
Optimizing settling conditions for treatment of liquid hog manure
1Acres International, Niagara Falls, ON, Canada.
Abstract:
Sedimentation is a widely used separation method for treating agricultural waste. There are several chemical and biological characteristics, which can affect the settling behavior and liquid waste. The optimization of cation balances and potential for nitrification are among these processes. In addition to sedimentation, it can also affect the dewaterability of the samples. Liquid hog manure was used during the laboratory based experiments to investigate the effects of Ca2+ and Mg2+ ions and nitrification inhibition on the overall settling and dewatering characteristics. The results indicated that settling and dewatering characteristics improved during the course of the experiments. However, the improvement in settling and dewatering characteristics was inconsistent and not statistically significant. Cation addition in aerated reactor increased the highest settling velocity (94%). The improvement in dewaterability, as quantified by capillary suction time, was also not consistent. The greatest filterability observed in the supernatant was a capillary suction time of 40 s for a M:D ratio of 2:1. Initial NH 4 + concentration was more important than the nitrification inhibitor, as the presence of nitrification inhibitor increased the nitrification rate by over 300% because of the high initial NH 4 + concentration and low volatile suspended solid. The results from these experiments provide the basis for further field evaluation of cation optimization.
More Related Videos
Related Concept Videos
Biological Treatment of Effluent and Waste Water
Methods of Medium Optimization
Optimizing Chromatographic Separations
Band broadening refers to spreading solute bands as they travel through the column. This broadening can impact resolution. Plate height (H) represents the length required for one theoretical plate. A lower plate height corresponds to...
Bioreactor Controls-II
Bioreactor Design and Operational System

