Combination of direct and indirect evidence in mixed treatment comparisons

G Lu1, A E Ades

  • 1MRC HSRC, Department of Social Medicine, University of Bristol, Canynge Hall, White Ladies Road, Bristol BS8 2PR, U.K. guobing.lu@bristol.ac.uk

Statistics in Medicine
|September 28, 2004
PubMed

Related Concept Videos

Crossover Experiments01:16

Crossover Experiments

Crossover experiments, also called the repeated-measurements design, is a study design in which all experimental units are exposed to all treatments in different periods. Crossover experiments are generally used in psychology, the pharmaceutical industry, agriculture, and medicine.
Crossover designs are performed even with smaller sample sizes since the samples can act as their controls. These are better than simple randomized trials since patients are exposed to all the treatments.
Blinding01:11

Blinding

Blinding is a commonly used method of not telling participants which treatment a subject is receiving. Blinding is a critical part of a randomized control trial or RCT. It reduces the bias that affects the results. In an RCT, blinding is used in the form of a placebo. A placebo effect occurs when untreated subjects falsely believe they have received the treatment and report improved symptoms. A placebo or a dummy treatment is administered to subjects to negate the bias caused by such an effect.
Multiple Comparison Tests01:13

Multiple Comparison Tests

Multiple comparison test, abbreviated as MCT, is a post hoc analysis generally performed after comparing multiple samples with one or more tests. An MCT will help identify a significantly different sample among multiple samples or a factor among multiple factors.
It would be easy to compare two samples using a significance alpha level of 0.05. In other words, there is only one sample pair to be compared. However, it would be difficult to identify a significantly different sample if the number...
Bioequivalence Experimental Study Designs: Repeated Measures, Cross-Over, Carry-Over, and Latin Square Designs01:15

Bioequivalence Experimental Study Designs: Repeated Measures, Cross-Over, Carry-Over, and Latin Square Designs

Bioequivalence experimental study designs play a pivotal role in testing the effectiveness of various treatments. Key among these are the repeated measures, cross-over, carry-over, and Latin square designs. In the repeated measures design, each subject receives all treatments, allowing for temporal comparisons. This type of design is useful in reducing variability but requires careful planning to avoid bias.The cross-over design, an economical method, involves sequential administration of...
Blind Procedures02:07

Blind Procedures

Ideally, the people who observe and record the children’s behavior are unaware of who was assigned to the experimental or control group, in order to control for experimenter bias. Experimenter bias refers to the possibility that a researcher’s expectations might skew the results of the study. Remember, conducting an experiment requires a lot of planning, and the people involved in the research project have a vested interest in supporting their hypotheses. If the observers knew which child was...
Factorial Design02:01

Factorial Design

Factorial Analysis is an experimental design that applies Analysis of Variance (ANOVA) statistical procedures to examine a change in a dependent variable due to more than one independent variable, also known as factors. Changes in worker productivity can be reasoned, for example, to be influenced by salary and other conditions, such as skill level. One way to test this hypothesis is by categorizing salary into three levels (low, moderate, and high) and skills sets into two levels (entry level...