Ozonolysis of tetramethylethylene: characterization of cyclic and open-chain oligoperoxidic products

The ozonolysis of tetramethylethylene (TME) in solution to high conversion in nonparticipating solvents at -60 degrees C yields predominantly oligoperoxides. For the first time, these products have been characterized using electrospray ionization mass spectrometry (ESI-MS) under soft ionization conditions. The predominant structure formed in reactions carried out in pentane (up to 2.0 M TME) is shown to be the cyclic hexamer of acetone carbonyl oxide (oligocarbonyl oxide with degree of polymerization, n = 6), but cyclic structures with n up to 19 are observed. A small proportion of the oligoperoxides formed are open-chain compounds with end groups that suggest that chain termination of oligocarbonyl oxides can occur through reaction with either water or hydrogen peroxide. Ozonolysis in dried butyl acetate similarly produces mainly cyclic oligoperoxides. However, ozonolyses carried out in undried butyl acetate yield mainly open-chain oligoperoxides, confirming that propagating carbonyl oxide chains are readily terminated by water. Relative amounts of the open-chain oligomers so-formed suggest that undried butyl acetate contains ca. 0.1% w/w water. The ozonolysis of TME in the participating solvent, methanol, at -60 degrees C yields 2-methoxyprop-2-yl hydroperoxide via reaction of acetone carbonyl oxide with methanol; no oligoperoxidic products are formed in this case.