Fabrication of microarrays on fused silica plates using the laser-induced backside wet etching method

A novel approach in the fabrication of microarrays of dye and protein on fused silica plates using the laser-induced backside wet etching (LIBWE) technique is described. The surface of fused silica plates was initially precoated using trimethoxysilane self-assembled monolayers (SAMs) and then etched using the LIBWE method to obtain the desired microstructures on the plate surface. Using this technique, the SAMs on the nonirradiated areas were able to survive the LIBWE process and were used as templates for the subsequent deposition of dye molecules or proteins via chemical bonding or physical adsorption. In the case of fused silica plates precoated with fluorinated SAMs, the LIBWE method is used to remove the SAMs to expose the etched silica surfaces, on which a thin layer of pyranine molecules can be site-selectively deposited using an aqueous solution of pyranine. In another application, an ethanol solution of rhodamine 6G was preferentially deposited onto the nonirradiated areas. In yet another application, bovine serum albumin was preferentially deposited onto the laser-irradiated areas; in this case, the fused silica plates were precoated with poly(ethylene oxide) SAMs. Interestingly, when an aqueous suspension of polystyrene (PS) microbeads was cast onto the fused silica precoated with the fluorinated SAMs, hexagonally close-packed PS microbeads were deposited into the etched cavities. Depositions of the dye, protein, and microbeads were confirmed by visualization using a fluorescence microscope and scanning electron microscope.