Effects of cleaning duration and water temperature on oxytocin release and milk removal in an automatic milking...

Four different methods of teat preparation during milking in an automatic milking system were studied in 2 experiments on Red Holstein/German Fleckvieh cross-breed cows. Milking routines used were milking: 1) without premilking teat preparation; 2) with one cleaning cycle (58 to 60 s) with cold (13 to 15 degrees C) water; 3) with one cleaning cycle with warm water (30 to 32 degrees C); or 4) with 2 cleaning cycles (122 s) with warm water. In experiment 1, milking characteristics were evaluated and milking routines were randomly assigned to 62 cows during 3 measuring periods of 24 h each. In experiment 2, 10 randomly selected cows were assigned to the same milking routines during 4 d and blood samples for oxytocin (OT) determination were taken during milking in addition to milk flow recording. Milk production, peak flow rate, total, and quarter milk yields showed no differences among treatments. Premilking preparation with cold water compared with warm water showed no differences in OT release, milk yield, peak flow rate, main milking time, average flow rate, or time until main milk flow. Baseline OT concentrations were consistently low. At the start of teat cup attachment without premilking teat preparation OT concentrations remained on the basal level but were elevated in all other treatments. By 30 s from the start of milking, OT concentrations were markedly increased in all treatments and were no longer different between treatments. In conclusion, the teat cleaning device used in the automatic milking system, either with warm or cold water, was suitable to induce milk ejection in cows before the start of milking.