Boosting sensitivity of organic vapor detection with silicone block polyimide polymers

We demonstrate that silicone block polyimide polymers have an unusually high sensitivity to nonpolar organic vapors, including chlorinated organic solvent vapors. When 0.18-5.34-microm-thick films of silicone block polyimide polymers were deposited onto 10-MHz thickness shear mode (TSM) oscillators, these films were implemented to detect parts-per-billion concentrations of trichloroethylene (TCE) with a detection sensitivity of 0.5-23.5 Hz per 500 ppb of vapor. With a film thickness of 3.4 microm (91.5-kHz frequency shift upon film deposition), optimized for the minimal sensor noise of 0.04 Hz, the calculated detection limit of sensor response (S/N = 3) was 3 ppb of TCE. Detection limits for other chlorinated organic solvent vapors, such as perchloroethylene (PCE), cis-1,2-dichloroethylene (DCE), trans-1,2-DCE, 1,1-DCE, and vinyl chloride (VC) were 0.6, 6, 6, 11, and 13 ppb, respectively. Assuming only the mass-loading response when deposited onto the TSM devices, silicone block polyimide polymers have partition coefficients of over 200 000 to parts-per-billion concentrations of TCE that make them at least 100 times more sensitive than other known polymers for TCE detection. We observed that unlike conventional polyimides, water sensitivity of the new hybrid polyimides is suppressed because of the silicone soft block. Water sensitivity is comparable with the sensor response to nonpolar organic vapors. The high sensitivity and long-term stability of these sensor materials make them attractive for ultrasensitive practical sensors.