Surface properties of diluted solutions of cyclohexanol and cyclopentanol in ethylene glycol

Saeid Azizian1, Nowrouz Bashavard

  • 1Department of Chemistry, Faculty of Science, Bu-Ali Sina University, Hamadan, Iran. sazizian@basu.ac.ir

Related Concept Videos

Stability of Substituted Cyclohexanes02:30

Stability of Substituted Cyclohexanes

This lesson discusses the stability of substituted cyclohexanes with a focus on energies of various conformers and the effect of 1,3-diaxial interactions.
The two chair conformations of cyclohexanes undergo rapid interconversion at room temperature. Both forms have identical energies and stabilities, each comprising equal amounts of the equilibrium mixture. Replacing a hydrogen atom with a functional group makes the two conformations energetically non-equivalent.
For example, in...
Disubstituted Cyclohexanes: cis-trans Isomerism02:37

Disubstituted Cyclohexanes: cis-trans Isomerism

Depending upon the different spatial orientation of the substituents, the disubstituted cycloalkanes exhibit two types of stereoisomers. The cis isomers have the substituents on the same side of the ring, whereas the trans isomers have the substituents on the opposite sides. These stereoisomers exhibit different physical properties and cannot be interconverted without breaking the carbon-carbon bonds.
In cyclohexane, the substituents can occupy different positions generating distinct isomers.
Physical Properties of Ethers02:17

Physical Properties of Ethers

Overview
An ether molecule has a net dipole moment due to the polarity of C–O bonds. Subsequently, boiling points of ethers are lower than those of alcohols of comparable molecular weight and slightly higher than those of hydrocarbons of comparable molecular weight (Table 1).
Ethers can act as hydrogen bond acceptors, making them more water-soluble than hydrocarbons, but since ethers cannot act as hydrogen bond donors, they are much less soluble in water than alcohols. Ethers are considered...
Conformations of Cycloalkanes02:29

Conformations of Cycloalkanes

Adolf von Baeyer attempted to explain the instabilities of small and large cycloalkane rings using the concept of angle strain — the strain caused by the deviation of bond angles from the ideal 109.5° tetrahedral value for sp3  hybridized carbons. However, while cyclopropane and cyclobutane are strained, as expected from their highly compressed bond angles, cyclopentane is more strained than predicted, and cyclohexane is virtually strain-free. Hence, Baeyer’s theory that was based on the...
Mass Spectrometry: Cycloalkane Fragmentation01:05

Mass Spectrometry: Cycloalkane Fragmentation

In mass spectrometry, cycloalkanes exhibit distinct fragmentation patterns due to the inherent stability of their molecular ions compared to linear or branched alkanes. The ring structure of cycloalkanes provides additional stability to the molecular ions, often resulting in prominent ion peaks in the mass spectrum.
For example, cyclohexane molecular ions have a mass-to-charge ratio (m/z) of 84, which tends to produce a stronger signal than linear alkanes like hexane. This stability comes from...
Types of Enols and Enolates01:19

Types of Enols and Enolates

Aldehydes and ketones form enols, although only about 1% of the enol is present at the equilibrium for simple monocarbonyl compounds. The enol form is undetectable for acetaldehyde, present as only 1.5 × 10−4 % of acetone, and present as only 1.2% of cyclohexanone. Two kinds of regioisomeric enols are possible for unsymmetrical ketones, and their net composition is 1% at equilibrium. This instability is due to the lower bond energy of C=C than the C=O group. The additional instability of enols...