Related Experiment Video
Updated: Aug 20, 2026

Ultrasound-Guided Acupotomy Release With Biomechanical Assessment For Trapezius Myofascial Pain Syndrome
Published on: May 29, 2026
The activity in the three regions of the trapezius under controlled loading conditions--an experimental and modelling
Garth R Johnson1, Anand D Pandyan
1Centre for Rehabilitation and Engineering Studies, Stephenson Building, University of Newcastle, Newcastle Upon Tyne NE1 7RU, UK. g.r.johnson@ncl.ac.uk
Background:
There is a degree of conflict in the literature regarding the biomechanical role of the three regions of trapezius. It is suggested that some of this may result from a lack of experiments using a well defined loading regime.
Objectives:
To study the activity of the three regions of trapezius under controlled load in order to gain further insight into its role in shoulder biomechanics.
Design:
The emg activity of the three regions of trapezius was studied on five subjects using a specially designed test system which allowed the application of either a uniaxial shrug force or a pure couple in the coronal plane.
Methods:
Test rigs were designed and constructed to measure isometric loads applied by shoulder shrugging and isometric pure moments produced in coronal plane abduction and adduction. Surface emg of the three regions of trapezius was performed simultaneously with loading.
Results:
The activity of upper trapezius was always present but changed little with the type of loading. Middle trapezius was dominant during both shrug and abduction whereas the lower fibres predominated during adduction.
Conclusions:
The use of a test system applying defined loading at the shoulder allows the detail analysis of trapezius muscle activity. The reproducible technique can be extended to other shoulder muscles.
Relevance:
The biomechanics of the shoulder calls for detailed analysis of the activity of all the interacting muscles. This paper describes a techniques which allows study of muscle activity under carefully defined loading.
Related Concept Videos
Load along a Single Axis
Consider a beam of length L subjected to a varying load, which is a combination of parabolic and trapezoidal load distribution along the x-axis. In this case, it is essential to determine the resultant loads, their locations, and...
Stress: General Loading Conditions
The shearing force, possessing potential directionality within the plane of the section, is simplified into two component forces running parallel to the x and y axes.
Residual Stresses in Bending
Normal Strain under Axial Loading

