Sample size and the detection of correlation--a signal detection account: comment on Kareev (2000) and Juslin and

Richard B Anderson1, Michael E Doherty, Neil D Berg

  • 1Department of Psychology, Bowling Green State University, Bowling Green, OH 43403, USA. randers@bgnet.bgsu.edu

Psychological Review
|January 6, 2005
PubMed

Related Concept Videos

Correlation of Experimental Data01:23

Correlation of Experimental Data

Dimensional analysis simplifies complex physical problems and guides experimental investigations, but it does not provide complete solutions. It identifies the dimensionless groups that influence a phenomenon, but experimental data is needed to establish the specific relationships and validate theoretical predictions.
For example, a spherical particle moving through a viscous fluid experiences drag. Dimensional analysis shows that the drag force depends on the particle's diameter, velocity, and...
Correlation and Regression00:53

Correlation and Regression

In statistics, correlation describes the degree of association between two variables. In the subfield of linear regression, correlation is mathematically expressed by the correlation coefficient, which describes the strength and direction of the relationship between two variables. The coefficient is symbolically represented by 'r' and ranges from -1 to +1. A positive value indicates a positive correlation where the two variables move in the same direction. A negative value suggests a negative...
Statistical Significance01:37

Statistical Significance

Once data is collected from both the experimental and the control groups, a statistical analysis is conducted to find out if there are meaningful differences between the two groups. A statistical analysis determines how likely any difference found is due to chance (and thus not meaningful). In psychology, group differences are considered meaningful, or significant, if the odds that these differences occurred by chance alone are 5 percent or less. Stated another way, if we repeated this...
Difference from Background: Limit of Detection01:05

Difference from Background: Limit of Detection

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...
Detection of Gross Error: The Q Test01:00

Detection of Gross Error: The Q Test

When one or more data points appear far from the rest of the data, there is a need to determine whether they are outliers and whether they should be eliminated from the data set to ensure an accurate representation of the measured value. In many cases, outliers arise from gross errors (or human errors) and do not accurately reflect the underlying phenomenon. In some cases, however, these apparent outliers reflect true phenomenological differences. In these cases, we can use statistical methods...
Calibration Curves: Correlation Coefficient01:10

Calibration Curves: Correlation Coefficient

In a linear calibration curve, there is a value called the calibration coefficient, denoted by 'r,' which measures the strength and the direction of association between two variables. The correlation coefficient value ranges from −1 to +1. A value of +1 indicates a perfect positive linear correlation, −1 denotes a perfect negative correlation, and 0 implies no correlation between the two variables. A positive correlation value establishes that as one variable increases, the other increases, and...