Related Experiment Video
Updated: Aug 19, 2026

Application of Design Aspects in Uniaxial Loading Machine Development
Published on: September 19, 2018
The distance between the load and the body with three bi-manual lifting techniques
1Laboratory for Back Research, State University Hospital, Rigshospitalet, T 2001 Copenhagen, Denmark.
Abstract:
Studies were made of two different techniques of bi-manual lifting with bent legs (A and B) and a technique of lifting with the back bent and the Knees almost extended (C). With technique A, the trunk was almost vertical, while with B it was erect and more forward inclined and the heel of the front foot kept in contact with the support. Two healthy subject samples (n = 18 and n = 16 respectively) were studied, both employing a force platform; with the second sample the back muscles were also evaluated by electromyography. The distance Delta L between the lines of gravity of the body and the load at the start of the lifts was shortest with technique A and longest with C. This was true whether the position of the feet was chosen spontaneously or was identical for all three techniques. The distance of the load from the body during the lifting movement was directly related to the distance at the start of the lift: the further away the load was at initiation of the lift, the further away it remained throughout the rest of the lift. A request to lift as close to the load as possible had a positive effect in shortening Delta L , but the amount of previously received instruction in lifting technique did not correlate with the spontaneously chosen Delta L.
More Related Videos
Related Concept Videos
Machines: Problem Solving II
Frames: Problem Solving I
Load along a Single Axis
Consider a beam of length L subjected to a varying load, which is a combination of parabolic and trapezoidal load distribution along the x-axis. In this case, it is essential to determine the resultant loads, their locations, and...
Three Force Member
For example, consider a dumpster connected to a pin support at point A and a pin attached to a hydraulic cylinder at point B.
Frames: Problem Solving II
Internal Loadings in Structural Members: Problem Solving
To illustrate this, let's consider a beam OC of 5 kN, inclined at an angle of 53.13° with the horizontal and supported at both ends. Determine the internal loadings...

