Related Experiment Video

Updated: Aug 16, 2026

Biocontained Carcass Composting for Control of Infectious Disease Outbreak in Livestock
14:34

Biocontained Carcass Composting for Control of Infectious Disease Outbreak in Livestock

Published on: May 6, 2010

Optimum handle height for animal-drawn mould board plough

L P Gite1

  • 1Crop Production Engineering Division, Central Institute of Agricultural Engineering, Nabi Bagh, Bhopal-462 018, India.

Applied Ergonomics
|February 1, 1991
PubMed

More Related Videos

Lab-Scale Model to Evaluate Odor and Gas Concentrations Emitted by Deep Bedded Pack Manure06:52

Lab-Scale Model to Evaluate Odor and Gas Concentrations Emitted by Deep Bedded Pack Manure

Published on: July 19, 2018

Measurement of the Hand Transmitted Vibration of the Human Hand Arm System During Operation of a Hand Tractor09:35

Measurement of the Hand Transmitted Vibration of the Human Hand Arm System During Operation of a Hand Tractor

Published on: June 16, 2021

Related Concept Videos

Optimal Foraging00:48

Optimal Foraging

How animals obtain and eat their food is called foraging behavior. Foraging can include searching for plants and hunting for prey and depends on the species and environment.
Maximum Deflection01:13

Maximum Deflection

When analyzing beams under unsymmetrical loads, such as a train moving on a bridge, it is crucial to accurately determine the points of maximum stress and deflection. The process involves identifying the maximum deflection of the beam, which may not always occur at its midpoint due to the uneven distribution of the load.
The maximum deflection occurs at a specific point, known as point O, where the tangent to the deflection curve is horizontal. To find point O, the slope of the tangent at any...
Placing Concrete01:17

Placing Concrete

The concrete is placed as close as possible to its final position to avoid segregation. The placed concrete is then fully compacted to expel the entrapped air, and the next layer of concrete is laid while the underlying layer is still in the plastic state. The rate at which concrete is placed and compacted is kept equal.
While placing concrete, care is taken to ensure that the concrete is laid in uniform layers, and hand shoveling and moving concrete using poker vibrators is avoided. Also,...
Design Example: Maintaining Level of an Embankment01:19

Design Example: Maintaining Level of an Embankment

Constructing a roadway embankment over uneven terrain requires precise leveling to ensure stability and proper drainage. Surveyors use a leveling instrument and staff to calculate ground elevations and determine the required fill material at each point along the embankment alignment.The process begins by positioning a leveling instrument near a benchmark with a known elevation. A backsight reading establishes the instrument height, which serves as a reference for subsequent measurements. A...
Design Example: Design of an Irrigation Channel01:27

Design Example: Design of an Irrigation Channel

Trapezoidal channels are widely used in irrigation systems due to their cost-effectiveness and efficiency in conveying water. Trapezoidal channels feature a flat bottom and sloping sides, making them stable and easier to construct compared to other shapes. The bottom width and side slope ratio are determined based on the required flow capacity and site conditions. The side slope is kept gentle for unlined channels to prevent soil erosion.Hydraulic parameters in channel design include the flow...
Lagrange Multipliers: Problem Solving01:30

Lagrange Multipliers: Problem Solving

A silo with a cylindrical base, flat bottom, and hemispherical roof is a common design in agricultural and industrial storage due to its structural efficiency and ease of construction. Optimizing its dimensions to maximize storage capacity for a given amount of material—i.e., a fixed surface area—is a classic problem in applied calculus and engineering design. The key parameters are the radius r of the base and the height h of the cylindrical section.The total volume of the silo is obtained by...