Joint statistics of the Lagrangian acceleration and velocity in fully developed turbulence

Alice M Crawford1, Nicolas Mordant, Eberhard Bodenschatz

  • 1Laboratory of Atomic and Solid State Physics, Clark Hall, Cornell University, Ithaca, New York, USA.

Physical Review Letters
|February 9, 2005
PubMed

Related Concept Videos

Velocity and Acceleration in Steady and Unsteady Flow01:11

Velocity and Acceleration in Steady and Unsteady Flow

In fluid mechanics, velocity and acceleration are key concepts for analyzing particle motion in both steady and unsteady flow. Consider a fluid particle moving along a pathline, where its velocity depends on its position and time. The particle's acceleration is obtained by differentiating the velocity with respect to time.
The acceleration can be generalized to any point in the flow, and expressed as components along three perpendicular directions, representing changes in velocity over time.
Velocity and Position by Graphical Method01:34

Velocity and Position by Graphical Method

Velocity and position can be calculated from the known function of acceleration as a function of time. The total area under the acceleration-time graph and the velocity-time graph gives the change in velocity and position, respectively. In the case of an airplane, its acceleration is tracked using the inertial navigation system. The pilot provides the input of the airplane's initial position and velocity before takeoff. The inertial navigation system then uses the acceleration data to calculate...
Angular Velocity and Acceleration01:11

Angular Velocity and Acceleration

We previously discussed angular velocity for uniform circular motion, however not all motion is uniform. Envision an ice skater spinning with their arms outstretched; when they pull their arms inward, their angular velocity increases. Additionally, think about a computer's hard disk slowing to a halt as the angular velocity decreases. The faster the change in angular velocity, the greater the angular acceleration. The instantaneous angular acceleration is defined as the derivative of angular...
Acceleration Vectors01:30

Acceleration Vectors

In everyday conversation, accelerating means speeding up. Acceleration is a vector in the same direction as the change in velocity, Δv, therefore the greater the acceleration, the greater the change in velocity over a given time. Since velocity is a vector, it can change in magnitude, direction, or both. Thus acceleration is a change in speed or direction, or both. For example, if a runner traveling at 10 km/h due east slows to a stop, reverses direction, and continues their run at 10 km/h due...
Tangential and Normal Components of Acceleration01:27

Tangential and Normal Components of Acceleration

In the study of particle motion, acceleration is often broken down into tangential and normal components to clarify how a particle's velocity changes over time. This approach relies on analyzing the geometry of the path and the dynamics of the motion. The tangential direction follows the path of motion and reflects changes in the particle's speed, while the normal direction points toward the center of curvature and captures changes in the direction of motion.The velocity of a particle moving...
Laminar and Turbulent Flow01:07

Laminar and Turbulent Flow

Fluid dynamics is the study of fluids in motion. Velocity vectors are often used to illustrate fluid motion in applications like meteorology. For example, wind—the fluid motion of air in the atmosphere—can be represented by vectors indicating the speed and direction of the wind at any given point on a map. Another method for representing fluid motion is a streamline. A streamline represents the path of a small volume of fluid as it flows. When the flow pattern changes with time, the streamlines...