The influence of familiarization on the reliability of force variables measured during unloaded and loaded vertical jumps

The purpose of this study was to determine the number of familiarization sessions required to obtain an accurate measure of reliability associated with force variables recorded during unloaded and loaded (30 and 60% of 1 repetition maximum squat [1RM]) static vertical jumps (SJ). Nine physically active men attended 4 separate testing sessions over a 2-week period. Force platform recordings of peak force, peak rate of force development (pRFD), average rate of force development, takeoff velocity, average power, and peak power were obtained for each jump. During each of the 4 testing sessions, 3 jumps were performed under each of the load conditions. The average of the force variables were used in the analysis. Familiarization was assessed using the scores obtained during the 4 separate testing sessions. Reliability was assessed by calculating intraclass correlation coefficients (ICCs) and coefficient of variation (CV) associated with the force variables. No significant differences (p > 0.05) were obtained between the testing sessions for any of the force variables. With the exception of pRFD, the force variables showed reasonably good levels of test-retest reliability (ICC range: 0.75-0.99; CV range: 1.2-7.6%). High levels of reliability can be achieved in a variety of force variables without the need for familiarization sessions when performing SJ under unloaded conditions and with loads of 30 and 60% of 1RM squat with physically active men.