Influence of specimen size and regional variation on long-term resin-dentin bond strength

Verify whether the dimension of a bonded specimen stored prior microtensile testing and its regional variation may affect the resin-dentin bond strength (BS) over time.

Thirty human third molars had a flat dentin surface exposed and all peripheral enamel removed. Two adhesive systems (Single-Bond and One-Step) were applied and composite resin crowns (Z250) were constructed. Teeth were divided into three groups (n = 5). Group A specimens were sectioned to obtain sticks to be tested in tension (0.5 mm/min) immediately. Group B specimens were stored in water for 6 months, before sectioning and testing. Group C specimens were sectioned; the sticks were stored for 6 months and tested. In groups A and B, the origin of the sticks, periphery and inner regions was controlled. Bond strength (BS) was expressed as an index that considers cohesive failures and estimated values of premature debonded specimens. One-way ANOVA and Tukey's test (alpha = 0.05) were used to compare groups A, B and C, and a second analytical approach (A and B) employed a two-way ANOVA (time versus regional differences) for each adhesive system.

For Single-Bond (SB), the BS for specimens in group A was higher than for groups B and C. For One-Step (OS), the BS in group A was higher than for B, which was in turn higher than for C. In the second group approach, no difference was found when the test was performed immediately; however, after 6 months, the inner sticks from group B showed significantly higher BS.

(1) The amount of decrease in BS is dependent on the specimen size; (2) the decrease in BS was greater for peripheral specimens than more centrally located specimens.