Related Experiment Video
Updated: Oct 9, 2026

Quantification of the Immunosuppressant Tacrolimus on Dried Blood Spots Using LC-MS/MS
Published on: November 8, 2015
Stability of ganciclovir sodium in 5% dextrose injection and in 0.9% sodium chloride injection over 35 days
J Parasrampuria1, L C Li, A H Stelmach
1Hospital Products Division, Abbott Laboratories, Abbott Park, IL 60064.
Abstract:
The stability of ganciclovir 1 and 5 mg/mL in 5% dextrose injection and in 0.9% sodium chloride injection was studied at 25 degrees C and 5 degrees C over 35 days. Ganciclovir (as the sodium salt) was added to 120 polyvinyl chloride bags containing either 5% dextrose injection or 0.9% sodium chloride injection to attain ganciclovir concentrations of 1 and 5 mg/mL. Thirty bags were prepared for each combination of drug concentration and i.v. solution. Half of the bags in each group were stored at 25 degrees C; the other half were stored at 5 degrees C. Samples withdrawn from all 120 bags immediately after preparation were frozen for later determination of initial concentration. At 7, 14, 21, 28, and 35 days after preparation, approximately 5-mL samples representing each test condition were withdrawn for analysis. The samples were visually examined, tested for pH, and assayed by high-performance liquid chromatography. There was no significant loss of ganciclovir under any of the study conditions over 35 days. All solutions were clear throughout the study period. The pH decreased slightly in both diluents at both ganciclovir concentrations but did not deviate from the manufacturer's range (9-11). Admixtures containing ganciclovir 1 and 5 mg/mL (as the sodium salt) in 5% dextrose injection and 0.9% sodium chloride injection were stable in polyvinyl chloride bags stored at 25 degrees C and 5 degrees C for 35 days.
Related Concept Videos
Nonlinear Pharmacokinetics: Drug Elimination for IV Bolus Injection
Following the administration of a single intravenous (IV) bolus injection, we can determine the concentration of the drug in the plasma at any given time. This calculation is achieved using a specific equation that integrates the values of Vmax and KM.
We can also...
Drug Product Stability
Pharmaceutical Alternatives: Stability-Related Therapeutic Nonequivalence
Drug Accumulation During Multiple Dosing: Repetitive IV Injections
Drug Accumulation During Multiple Dosing: Intermittent IV Infusions
Determination of Multiple Dosing Parameters: Steady-State, Minimum and Maximum Concentrations

